Abstract:This paper investigated the influence of the electric pulses on the flow behavior and plasticity of the advanced high strength steel (AHSS) Dual Phase, DP980. In order to isolate the thermal effect of the electric pulses, two kinds of uniaxial tensile tests at the same testing temperature were carried out: (1) isothermal tensile test carried out in an environment cabinet and (2) electrically-assisted isothermal tensile test. The stress–strain curves were recorded and compared. The results indicate that at the same testing temperature, the stress–strain curves obtained by test (1) are generally lower than curves deserved by test (2). It demonstrates that electric pulses can not reduce the flow stress when compared with the case that without electric pulse which is contrary to the traditional electroplastic effect. Another result is that when the testing temperature is not more than 573K, the stress–strain curves obtained by both tests are higher than the tension curve in room temperature and the cases are opposite when testing temperature is more than 573K. In addition, the elongation improvement is not observed as well in the stress–strain curves. The difference between the two tests when compared the cross section shrinkage rate and the fracture elongation rate is not obvious. From another aspect to study the athermal effect of the electric pulse, tests with only varying the peak current density or pulse frequency at the same testing temperature were conducted. The results once again show that no evident difference between the stress–strain curves. It confirms that no athermal effect exists in DP980. However, with temperature elevated to 473K, the material is strengthened and then weakened as temperature exceeds 473K. Scanning electron microscope (SEM) analysis was adopted to better understand the observed phenomena. The results show that the decomposion of the martensite and the thermal effect are the main reason that attributes to the strength variation. Fracture surface morphology analysis indicates that the appearance of the shallower and smaller dimples as well as fracture platform represents the bad plasticity when increasing temperature. Meanwhile, fracture pattern is transformed from brittle fracture in test (1) to ductile fracture in test (2) when tensioned at 673K.

Electric pulse assisted stress relaxation and springback reduction of DP980 high strength steel sheet

Investigation on Transient Electrically-Assisted Stress Relaxation of Qp980 Advanced High Strength Steel

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Investigation on the Electrically-Assisted Stress Relaxation of Az31b Magnesium Alloy Sheet

Identification of Advanced Constitutive Model Parameters Through Global Optimization Approach for DP780 Steel Sheet

Experimental research of the bending springback property on advanced high strength steel

Experimental Investigation on Electroplastic Effect of Dp980 Advanced High Strength Steel

Study on Springback for TRIP-aided Steel Sheet

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Study of Microstructure and Spring Back Mechanism of High Strength Dualphase Steel During Bending Plastic Deformation

Study on Process Parameters and Springback Rule for Stamping of High Strength Steel Sheet

Sensitivity Analysis of Effect of Material Properties to Spring-back of High Strength Steel

Springback control and deformation analysis for electromagnetically assisted bending of U-shaped parts

Springback Control in Complex Sheet-Metal Forming Based on Advanced High-Strength Steel

Analytical prediction of springback based on residual differential strain during sheet metal bending

Investigation into Springback Characteristics of Two Hss Sheets During Cold V-Bending

Measurement of the Bauschinger Behavior of Sheet Metals by Three-Point Bending Springback Test with Pre-Strained Strips

Influences of the Evolving Plastic Behavior of Sheet Metal on V-bending and Springback Analysis Considering Different Stress States

Numerical Simulation and Experimental Validation of Distortional Springback of Advanced High-Strength Steel Sheet Metal Forming

Description of elastic–plastic stress–strain transition in cyclic plasticity and its effect on springback prediction