Abstract:Springback is an important issue for the application of advanced high-strength steels (AHSS) in the automobile industry. Various studies have shown that it is an effective way to predict springback by using path-dependent material models. The accuracy of these material models greatly depends on the experimental test methods as well as material parameters calibrated from these tests. The present cyclic sheet metal test methods, like uniaxial tension–compression test (TCT) and cyclic shear test (CST), are nonstandard and various. The material parameters calibrated from these tests vary greatly from one to another, which makes the usage of material parameters for the accurate prediction of springback more sophisticated even when the advanced material model is available in commercial software. The focus of this work is to compare the springback prediction accuracy by using the material parameters calibrated from tension–compression test or cyclic shear test, and to further clarify the usage of those material parameters in application. These two types of nonstandard cyclic tests are successfully carried out on a same test platform with different specimen geometries. One-element models with corresponding tension–compression or cyclic shear boundary conditions are built, respectively, to calibrate the parameters of the modified Yoshida–Uemori (YU) model for these two different tests. U-bending process is performed for springback prediction comparison. The results show, for dual phase steel (DP780), the work hardening stagnation is not evident by tension–compression tests at all the prestrain levels or by cyclic shear test at small prestrain γ = 0.20 but is significantly apparent by cyclic shear tests at large prestrain γ = 0.38, 0.52, 0.68, which seems to be a prestrain-dependent phenomenon. The material parameters calibrated from different types of cyclic sheet metal tests can vary greatly, but it gives slight differences of springback prediction for U-bending by utilizing either tension–compression test or cyclic shear test.

Investigation into Springback Characteristics of Two Hss Sheets During Cold V-Bending

Investigation on V-Bending and Springback of Laminated Steel Sheets

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Analytical and Numerical Prediction of Springback of SS/Al-Alloy Cladded Sheet in V-Bending

Influences of the Evolving Plastic Behavior of Sheet Metal on V-bending and Springback Analysis Considering Different Stress States

Experimental research of the bending springback property on advanced high strength steel

Experimental study and numerical simulation on springback of Ti-6Al-4V alloy under hot U-bending

Determining the Coefficients of a Homogeneous Anisotropic Hardening Model for Ultrathin Steel Sheets

Study on bending springback behavior of laminated steel sheet

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Describing the Non-Saturating Cyclic Hardening Behavior with a Newly Developed Kinematic Hardening Model and Its Application in Springback Prediction of DP Sheet Metals

Sensitivity Analysis of Effect of Material Properties to Spring-back of High Strength Steel

Research on the Springback Behavior of 316LN Stainless Steel in Micro-Scale Bending Processes

An Analytical Model for Predicting Springback and Side Wall Curl of Sheet after U-bending

An Analytical Model for Predicting Sheet Springback after V-bending

Cyclic Sheet Metal Test Comparison and Parameter Calibration for Springback Prediction of Dual-Phase Steel Sheets

Numerical Simulation and Experimental Validation of Distortional Springback of Advanced High-Strength Steel Sheet Metal Forming

Springback prediction of advanced high strength steel part based on Yoshida-Uemori hardening model

Study on Process Parameters and Springback Rule for Stamping of High Strength Steel Sheet

Finite element modeling for analyzing the production of high-strength steel sheets for automobile parts