Abstract:Sheet metals usually experience various loading paths such as uniaxial tension, uniaxial compression, biaxial tension, and simple shear during the forming process. However, the existing constitutive models cannot always accurately describe blanks’ anisotropic yield and plastic flow behavior of blanks under all typical stress states. Given this, this paper improves the Eyld2000-2d yield criterion by introducing hydrostatic pressure to the A-Eyld2000-2d yield criterion that can describe the strength differential effect of materials. Meanwhile, to control the curvature of the yield surface more effectively, the near-plane strain yield stresses were added in the parameter identification process to calibrate the exponent m, so that the exponent is no longer considered as a constant value. Taking the widely used AA6016-T4, AA5754-O, DP980, and QP980 blanks in the automotive stamping industry as an example, the effectiveness of the new model and different parameter identification methods was verified by predicting experimental data under various simple and complex loading paths. Subsequently, the new model employing the optimal parameter identification strategy was compared with four widely used asymmetric yield criteria under associated and non-associated flow rules, including CPB06, LHY2013, S-Y2004, and Hu & Yoon2021, to further verify the accuracy of the proposed constitutive model. The results indicate that parameter identification strategy with variable exponent can significantly improve the flexibility of the yield criterion in describing the plastic anisotropy of blanks. Compared to the other yield criteria examined in this work, the new model provides the best prediction accuracy for the yield stresses and plastic flows of all blanks, especially in the near-plane strain and simple shear stress states. Modeling under the concept of anisotropic hardening can more accurately capture the evolving plastic behavior of blanks than isotropic hardening.

Application of distortional plasticity framework to EDDQ and TRIP steel sheets: Prediction of latent hardening and its influence on springback

Springback after the Lateral Bending of T-Section Rails of Work-Hardening Materials

Description of elastic–plastic stress–strain transition in cyclic plasticity and its effect on springback prediction

An application of fully coupled ductile damage model considering induced anisotropies on springback prediction of advanced high strength steel materials

Modeling Techniques for Strain-Range-Dependent Hardening Behavior of Low-Yield-Point Steel Shear Panel Dampers

Characterization of kinematic and distortional hardening by cyclic twin-bridge shear tests for sheet metal with inverse engineering approach

Effect of complicated deformation behaviors during cold stamping on springback prediction of DP980 steel

Machine learning for extending capability of mechanical characterization to improve springback prediction of a quenching and partitioning steel

Analytical prediction of springback based on residual differential strain during sheet metal bending

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Distortional hardening revisited: Advanced strength prediction model after multi-directional forming

Effects of Hardening Model and Variation of Elastic Modulus on Springback Prediction in Roll Forming

Non-associated anisotropic plasticity of metal sheets based on the distortional concept

Modeling of Eyld2000-2d Anisotropic Yield Criterion Considering Strength Differential Effect and Analysis of Optimal Calibration Strategy

Material Modeling of Hot-Rolled Steel Sheet Considering Differential Hardening and Hole Expansion Simulation

Modeling of distortional hardening including plane strain tension and pure shear for a TWIP steel

A strain rate-dependent distortional hardening model for nonlinear strain paths

Analysis of springback for multiple bending considering nonlinear unloading-reloading behavior, stress inheritance and Bauschinger effect

Spring Back Behavior of Large Multi-Feature Thin-Walled Part in Rigid-Flexible Sequential Loading Forming Process

Prediction of Work-Hardening Behavior under Various Loading Paths in 5083-O Aluminum Alloy Sheet Using Crystal Plasticity Models

Investigation on the effect of friction and material behavior models on the springback simulation precision: application to automotive part B-Pillar and material TRIP800 steel