Abstract:The new developed metal/composite co-cured material composed of carbon fiber–reinforced plastic and Al phases has been increasingly applied for manufacturing of attitude control flywheel in aerospace industry. However, drilling of co-cured material is still a challenging task to produce holes with high quality and low cost in the assembly chain and dynamic balance debugging of attitude control flywheel. In other words, the relevant mechanisms and experimental findings involved in the drilling process of carbon fiber–reinforced plastic/Al co-cured material is not clearly defined, which impedes the progress of attitude control flywheel production. To this end, this article specially addresses the experimental studies on the drilling process of carbon fiber–reinforced plastic/Al co-cured material with standard TiAlN-coated cemented carbide twist drill. The significance of this work aims to reveal the regardful cutting responses of the hole characteristics and tool wear modes during the practical drilling process of co-cured material. A full factorial experiment including three levels of feed rate and four levels of cutting speed was performed. The hole diameter shows different values in different positions while it indicates consistent pattern regardless of the cutting variables: the largest in the Al phase, followed by the upper and lower carbon fiber–reinforced plastic phases, respectively. Grooves and matrix degradation are the major machining defects for carbon fiber–reinforced plastic layers, while a great chip debris adhered to the machined surface is the case for Al layer. Subsequent wear analysis showed that abrasion was mainly maintained at the vicinity of major/minor cutting edges and drill edge corner, followed by chip adhesion on the chisel edge region. Carbide substrate of drill flank face is exposed, and thereafter cavities are formed under the strong mechanical abrasion. These results could provide several implications for industrial manufacturers during the attitude control flywheel production.

The Motorbike Crankcase Hole Series Drill Hinge Composite Process Craft

Two-side process craft of motorbike engine cylinder

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Three-side process special machine tool design for motorcycle engine cylinder

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

High-power Diesel Engine Crankshaft Cabinet Precision Machining Technology

Accelerating Axle Gear-Shift Hole Processing Technique Improvement of Cnc Equipment Headstock

Diesel Fuel Injection Pump Body Complex Hole Machining Accuracy Control Technology

Special Fixture Designed for the Fine Boring of Auto Engine Cylinder

Design and development of a five-axis machine tool with high accuracy, stiffness and efficiency for aero-engine casing manufacturing

Research on straightness error detection and quality control of multi-crankshaft bores for large medium speed engine block

The design of bearing processing technology and fixture

Process Improvement Of Semi-biuld Marine Crankshaft

Hole quality and tool wear when dry drilling of a new developed metal/composite co-cured material

Improvement of Processing Special-Hole Drill

Structural behavior of the deep hole internal grinding machine structure with artificial granite material

Composite Die Design of Deep Drawing Flanging Trimming and Punching Bottom Hole

Structural Design and Spatial Geometric Error Modeling of the Machine Tool for Implant Denture

Machining fixture and deformation control of aero-engine thin-walled casing

CNC Process Analysis and Fixture Design of Crank Shaft

The Engine Casing Machining Holes Repairing Based on Vibration Wire Feeding