Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Study On Technology Strategies For Guarantee Machining Precision Of Large-Scale Integrated Aircraft Parts

Machining Distortion Prediction of Aerospace Monolithic Components

Study on key technologies of straightening large-scale integrated part's distortion due to machining

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Research and Application of High Precision Machining Technology for Super-Large Integral Frame Parts of Aluminum Alloy

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Finish Machining Condition Evaluation Technology for Aircraft Fuselage-wing Joints

Research on Rapid and Accurate Fixture Design for Non-Intervention Machining of Complex Parts

Machining fixture and deformation control of aero-engine thin-walled casing

Development Trend of NC Machining Accuracy Control Technology for Aeronautical Structural Parts

Research on Precision Machining Technology of Thin-walled Parts

Responsive fixture design using dynamic product inspection and monitoring technologies for the precision machining of large-scale aerospace parts

3D Machining Allowance Analysis Method for the Large Thin-Walled Aerospace Component

Precision CNC machining and ways to achieve it

Study on the Machining Distortion of Thin-walled Part Caused by Redistribution of Residual Stress

Study of distortion on milled thin-wall aluminum parts influenced by initial residual stress and toolpath strategy

Finite element analysis of residual stresses and thin plate distortion after face milling

Research progress in machining technology of aerospace thin-walled components

Machining deformation of single-sided component based on finishing allowance optimization

A Technique for Integrated Compensation of Geometric Errors and Thermal Errors to Improve Positional Accuracy of Hole Machining in Large-Size Parts