Abstract:Springback is one of the most important problems that should be compensated in sheet metal forming process with the increasing application of advanced high strength steels and light-weight alloys. In the finite element analyses for the springback, accurate modeling of Bauschinger effect, transient behavior and permanent softening under cyclic loading has been recognized as the most critical hardening behavior in the constitutive modeling aspect. However, if parts of these hardening behavior are not well modelled, is the accuracy of springback prediction seriously deteriorated? To answer this question, in this paper the significance of Bauschinger effect and transient behavior, permanent softening and unloading modulus in springback prediction were estimated using the springback problem of U-draw/bending simulations proposed at Numisheet2011 Benchmark. A recent anisotropic non-linear kinematic (ANK) model [Zang S, Guo C, Thuillier S, Lee M. A model of one-surface cyclic plasticity and its application to springback prediction. Int J Mech Sci 2011;53:425–35.] was adopted to estimate the significance of hardening behavior and unloading modulus because of its special feature. The ANK model can predict exactly the same monotonous stress–strain curves for different hardening schemes, while different Bauschinger effect and transient behavior under one-dimensional cyclic loading can be also modelled. This feature is quite suitable to quantitatively evaluate the effects of the aforementioned hardening behaviors in springback prediction. Initial anisotropy is described by the anisotropic yield function Yld2000-2d. The unloading behavior is also considered by defining Young's modulus as a function of equivalent plastic strain. Several quantitative analyses were carried out to distinguish the effect of each hardening component and unloading elastic modulus scheme. Finally, the predicted springback by different models were compared with experiments for both as-received and pre-strained DP780 steel sheets.

Experimental Study on Effect of Drawbead on the Springback of Sheet Metal

Development of Drawbead Investigation in Sheet Metal Forming Technology

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Study on the drawbead setting of the large deformation area in a trunk lid

Simulation and Application of Drawbead in Sheet Metal Forming

Restraint Model of Draw Bead and Experimental Investigation

Study on Factors Affecting Springback and Application of Data Mining in Springback Analysis

Study on Process Parameters and Springback Rule for Stamping of High Strength Steel Sheet

Modification of equivalent draw bead restraining force and geometric parameters based on experimental data

Size Effect Affected Springback in Micro/meso Scale Bending Process: Experiments and Numerical Modeling

Sensitivity Analysis of Effect of Material Properties to Spring-back of High Strength Steel

Analysis on the Effects of Numerical Simulation Precision on Springback Prediction

Investigation on compression-springback performance of the SUS301 stainless steel gasket considering the residual stress

Study the Influence of Geometric Parameters on Springback in T-Section Aluminum Alloy Window Trim Strip Sheets Forming

Research on springback characteristic in flexible multi-points 3D stretch-bending process

Springback control and deformation analysis for electromagnetically assisted bending of U-shaped parts

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

Study of the Influence of Element Size and Number of Integration Points on Accuracy of Sheet Springback Prediction

Investigation of springback during electromagnetic-assisted bending of aluminium alloy sheet

Optimization of Process Parameters of U-Shape Sheet Metal Based on Compensation of Geometric Springback Value

Determination of influential springback parameters in U-bending test