Study of the Influence of Element Size and Number of Integration Points on Accuracy of Sheet Springback Prediction

ZHANG Yang,ZANG Shun-lai,DING Ri-xian,GUO Cheng

DOI: https://doi.org/10.3969/j.issn.1007-2012.2010.05.003

2010-01-01

Abstract:Springback is one of the drawbacks in sheet metal forming process,and is the most difficult one to be accurately predicted in numerical simulations.The accuracy of sheet springback prediction is influenced by many factors,such as constitutive models,element type and size,contact models and numerical algorithms.Adopting ABAQUS finite element analysis software,the draw bending springback was studied.The influences of number of integration points and element size of shell element on the accuracy of springback prediction and the time cost were especially investigated.The results show that,the accuracy of springback prediction tend to increase with the increasing of number of integration points and the decreasing of element size,but the time cost increase also.However,the accuracy of springback prediction obtained for the contact angles being 16° is similar to that for 5°.In addition,the accuracy of springback prediction simulated by 7 integration points lies between those of 25 and 51 integration points.These are different with the traditional recognitions,that the number of integration points should between 25 and 51,and the contact angle less than 10°.Based on the results,a higher accuracy of springback prediction and a lower time cost could be expected in the numerical simulation of sheet metal forming process.