Abstract:Polycrystalline Ni3Al-based superalloy with up to 70% <math>γ′</math> phase owns excellent strength at around 1100 °C. It has been successfully used as a substitute for turbine blade crown, which is one of the aircraft components working in the severest environment (i.e., sometimes nearly overheating). However, few studies concentrate on the coarsening resistance and phase thermal stability in this newly designed polycrystalline superalloy at the working temperature, hence, directional coarsening behavior of primary <math>γ′</math> <math>(γI′)</math> has remained restricted. This paper investigated directional coarsening behavior of <math>γI′</math> during aging treatment (1100 °C) after overheating at 1270 °C with furnace cooling (SFA), air cooling (SAA) and water cooling (SWA) respectively. It clearly showed that <math>γI′</math> grew into lamellar and gradually became irregular during the directional coarsening process. Moreover, its morphological combination mode was illustrated. Since parallel short lamellar <math>γI′</math> connected each other, long lamellar formed. When perpendicular long lamellar <math>γI′</math> connected each other, it became L-type or T-type, i.e., precursor of irregular <math>γI′</math>. The kinetics of directional coarsening regime of <math>γI′</math> was in line with the matrix-diffusion-controlled (MDC) theory according to the evaluation of <math>γI′</math> size. This was caused by higher migration of <math>γI′</math> interfaces than the diffusion of solute elements. It was also confirmed that driving force of directional coarsening mainly depended on the competition of elemental diffusion, lattice misfit distribution and <math>γ</math> channel distance.

Microscopic Phase-Field Calculate on Aging Behavior of Ni75Al21.5Ti3.5 Alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Influence of Cooling Rate on the Formation of Bimodal Microstructures in Nickel-Base Superalloys During Continuous Two-Step Aging

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Precipitation Sequence of Middle Al Concentration Alloy Using the Inversion Algorithm and Microscopic Phase Field Model

Inversion calculation of the interatomic potentials for Ni0.75AlxMo0.25-x alloy employing microscopic phase-field model

Coarsening kinetics of γ′ phase in isothermal aged high Al content Ni–17 at.% Al alloy

COMPUTER SIMULATION FOR PRECIPITATION PROCESSO Ni_<75>Al_<2.5>V_<22.5> ALLOY WITH THE MICROSCOPIC PHASE-FIELD METHOD

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

Precipitate Behavior and Microstructure Evolution of Γ’ Phase in Ni-Al Alloys with the Internal Elastic Strain

Atomic-scale computer simulation of mixture precipitation mechanism for Ni75AlxV25-x alloy

Phase-field simulation of re-dissolution of γ′ phase in Ni–Al alloy by continuous and second-order aging treatment

Microscopic phase-field study on L12 interface properties of Ni75Al18Cr7 superalloy

Microstructure evolution behavior of Ni3Al (γ′) phase in eutectic γ-γ′ of Ni3Al-based alloy

Effect of Heat Treatment on the Microstructure of Multiphase Nial-Based Alloy

Linear evolution of the γ′-(Ni, Cu)3Al phase composition in Cu-based high-temperature alloys

Directional coarsening behavior of primary γ′ phase in Ni3Al-based superalloy during aging heat treatment

Modeling the microstructural evolution of Ni-base superalloys by phase field method combined with CALPHAD and CVM

Insight into the aging behavior of a novel Al-Li-Cu-Mg alloy

Effects of Plastic Deformation and Aging Treatment on Phase Precipitation in Ti2AlNb Alloy

Phase-field simulation of early-stage kinetics evolution of γ' phase in medium supersaturation Co-Al-W alloy