Abstract:Blast furnace (BF) ironmaking is the most important process that produces hot metal (HM) from iron-bearing materials continuously, rapidly, and efficiently. To date, the process is considered to have reached its limit in view of the achieved high process efficiency. In addition, the required high-quality materials are expensive and gradually getting depleted. Hot gas injection (HGI) into the shaft of the BF is an emerging technology recognized potential to solve the aforementioned problems. However, so far, limited information and studies are available, most of which are preliminary studies with regard to the feasibility and aerodynamics of the technology. This hindered the understanding and thus the effective use of this technology. This work presents a numerical study of the multiphase flow, heat, and mass transfer in a BF by a CFD-based process model. The effects of injection composition in terms of CO and CO2 contents in HGI are studied first. The calculated results reveal that HGI of 100% CO delivers the best BF performance. Then, the effects of key variables in relation to HGI of 100% CO, including position, rate, and temperature, are systematically studied. The in-furnace states and overall performance parameters have been analysed in detail. The results show that, through appropriate control of the injection variables, it is possible to achieve improved BF performance including low fuel rate and high productivity, which are considerably affected by the HGI parameters. The BF process model is also demonstrated to be a cost-effective tool in optimizing the key variables of HGI in BF for obtaining optimum process efficiency.

Production of High Quality Iron Castings by Duplex Melting with Blast and Induction Furnaces

Effect on the Melt Quality of Cast Iron of Duplex Short-Cut Melting Process with Blast and Induction Furnaces

A Study of Duplex Melting Process with Blast and Medium Frequency Furnaces in the Production of Cast Iron

Study on Optimizing the Sintering Proportioning in Masteel

Optimization of V-Process for Cast-Iron Boiler Plate

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Research Status of High-Manganese High-Aluminum Steel and Key Points of Continuous Casting

Design and Optimization of Casting Technology for Steel Beam

Mass Flow Control and Its Economic Benefit in High Efficiency Continuous Casting of Billet

Mechanical characterization and quality of iron castings using optimized mold design: simulations and experimental validation

Strip Casting Technique Modification for Sintered NdFeB

Quality Improvement of 60 Steel Billets in Kunsteel

Production process and quality control of hollow driving shell casting for large wind power

Smelting Practice with Low Grade Iron Ore at 3200m~3 Blast Furnace of TISCO

Improved iron-tolerance in recycled aluminum alloys via direct strip casting process

Efficient and economical manufacture of heavy steel castings

Performance Enhancements of High-Pressure Die-Casting Die Processed by Biomimetic Laser-Remelting Process

Microstructure and mechanical behavior of a low-density Fe–12Mn–9Al–1.2C steel prepared using centrifugal casting under near-rapid solidification

Numeral Thermal Analysis and Judging Technique of Cast Iron Melt Quality Characterization

Recent progress and development of ironmaking in China as of 2019: an overview