Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Quality Improvement of 60 Steel Billets in Kunsteel

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Study on the synergistic effect of electromagnetic stirring and mechanical reduction on the improvement of the internal homogeneity of high-carbon steel billet

The Effect of Temperature, Cooling Rate and Casting Speed on Quality of Continuous Cast Steel Billets

Enhancing the Quality of Electrotechnical Steel Grade Slab Billets via Electromagnetic Stirring in the CCM Secondary Cooling Zone

Study and Application on Internal Quality Model Based on Intelligence Methods in Continuous Casting Billet

Homogenization Path Based on 250 mm × 280 mm Bloom under Mixed Light and Heavy Presses: Simulation and Industrial Studies

Improving Inner Quality in Continuous Casting Rectangular Billets: Comparison Between Mechanical Soft Reduction and Final Electromagnetic Stirring

Simulation and Experimental Study on the Effect of Superheat on Solidification Microstructure Evolution of Billet in Continuous Casting

Influence of Electromagnetic Swirling Flow in Nozzle on Solidification Structure and Macrosegregation of Continuous Casting Square Billet

Study on Optimizing the Sintering Proportioning in Masteel

Improvement in Castability of Al-Killed Steel in Billet Casters by Process Optimization

Technology Development of High Toughness and Ultra-heavy Plate Rolled by 400mm Continuous Casting Billet

Design and Optimization of Casting Technology for Steel Beam

Effect on Position of Electromagnetic Stirring on Inclusion Behaviors in Billet

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Optimization of Billet Tube Mold Designs for High-Speed Continuous Casting

Corner Structure Optimisation Design of Billet Mould Tube for Q235 with High Casting Speed

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Cleanliness of molten steel in continuous casting tundish

Numerical and Experimental Study on Carbon Segregation in Shaped Billet of Medium Carbon Steel with Combined Electromagnetic Stirring.