Abstract:In this paper, the competing requirements of material strength, casting formation and residual stress are considered in the design of a large bulkhead integral isothermal forging die using a design approach that incorporates an outer ring plus a die body. Thermal stress assembly was conducted to resolve the various manufacturing issues encountered in the production of this large-scale casting. This paper also proposes a design method for an expansion joint and material-saving holes to homogenize the cross-sectional thickness of the casting die by solving problems associated with defects and hot cracking during the casting process. The finite element method was used based on the equivalent liquid level descending method, the Niyama criterion, etc., to analyze the pouring of the sand model with different risers to choose the casting process. To resolve the occurrence of hot cracks during production, the design was optimized and the process was improved in combining with the simulation analysis result, after which carrying out another finite element analysis and by re-verifying the production process again. The results show that the simulated porosity, shrinkage and stress distribution are in accord with the practical production status. Based on the mechanical properties and a microstructure analysis, the tension strength of the K3 casting die at 950 °C is approximately 635 MPa, and the microstructures are typical dendrites. However, through the simulation, practical production, and analysis of the mechanical properties and microstructure, the die design method proposed in this paper offers benefits in solving casting forming problems and hot cracking of an integral oversized titanium bulkhead casting die, and a K3 superalloy die with a weight of 7.8 tons was successfully cast.

Performance Enhancements of High-Pressure Die-Casting Die Processed by Biomimetic Laser-Remelting Process

Cover Die Service Life Improvement by Biomimetic Laser-Remelting Process and CAE Simulation

Method for Improvement of Die-Casting Die: Combination Use of CAE and Biomimetic Laser Process

Influence and Application of Laser Parameters on Unit of H13 Steel by Laser Remelting Process

Bionic Laser Surface Remelting for the Wear Performance after Thermal Fatigue of B2 Die Steel Based on Surface Stress Simulation

Laser Bionic Strengthening Local Grid of Mould Surface

Achieving high hardness and wear resistance in phase transition reinforced DC53 die steel by laser additive manufacturing

Innovative Hybrid High-Pressure Die-Casting Process for Load-Bearing Body-In-White Structural Components

Effect of higher laser power remelting on porosity and mechanical performance of part built by laser powder bed fusion

Effect of laser remelting on printability, microstructure and mechanical performance of Al-Mg-Sc-Zr alloy produced by laser powder bed fusion

A method for yield and cycle time improvements in Al alloy casting with enhanced conductivity steel for die construction

Influences of laser remelting on mechanical performances of AISI4140 steel

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead

Thermal fatigue life and improvement mechanism of Fe-based coatings on H13 extrusion die by laser additive remanufacturing

The property of die-casting dies of wiper repaired by laser welding with filler wire

Effect of Composition on the Mechanical Properties and Wear Resistance of Low and Medium Carbon Steels with a Biomimetic Non-Smooth Surface Processed by Laser Remelting

Investigation on Microstructure and Performance of Boron Cast IronCylinder Liner with Laser Remelting

The Effect of Laser Remelting on the Microstructure and Mechanical Properties of the Bonding Interface in a Hybrid Metal Additive Manufacturing Process

Development Trend in Composition Optimization, Microstructure Manipulation, and Strengthening Methods of Die Steels under Lightweight and Integrated Die Casting

Die-Casting Die Design Based on the Application of Cae Simulation