Abstract:Journal of Thermoplastic Composite Materials, Ahead of Print. In the interest of developing a comprehensive understanding of the drilling process using the hole saw tool, this article aims to build a three-dimensional (3D) micromechanical model representing the orthogonal cutting of CFRP using one tooth of the hole saw tool. For this purpose, a finite element model is developed using Abaqus Explicit code. The influence of various drilling parameters like rake angle, inclination angle and cutting-edge radius on the drilling quality is explored. Especially, chip formation mechanisms, cutting force and lateral damage are analyzed. Through finite element simulations and computational analyses, it is found that these outputs results are highly influenced by drilling parameters. When the fiber orientation angle is set to 0°, increasing the rake angle results in a change in the chip formation mechanism from buckling to bending. In contrast, with a fiber orientation angle of 90°, bending and shear governs the chip formation process, irrespective of the rake angle. In both cases, whether the fiber orientation angle is 0° or 90°, chips tend to fragment more favorably with increasing the inclination angle. Regarding the cutting-edge radius, when the fiber orientation angle is 0°, an increase in the cutting-edge radius leads to a transition in the chip-forming mechanism from buckling to bending. However, for a fiber orientation angle of 90°, the chip formation remains governed by bending even as the cutting-edge radius changes. Decreasing the rake angle, the inclination angle, and the cutting-edge radius contribute to a reduction of the cutting force. As the inclination angle and the cutting-edge radius increase, the lateral damage increases, while the rake angle has showed a negligible impact on the damage. These results provide a guidance on the appropriate hole saw tool parameters for a good drilling quality namely, a rake angle of 20°, an inclination angle of 5° and a cutting-edge radius of 0.03 mm.

Three Dimensional Simulation and Experimental on Drilling of CFRP

Study on Robot Automatic Drilling of Carbon Fiber Reinforced Plastics (CFRP)

Simulation and experimental research on longitudinal-torsional ultrasonic vibration drilling of CFRP/Ti laminates

Experimental Study on Drilling Process of a Newly Developed CFRP/Al/CFRP Co-Cured Material

Study on dedicated drill bit design for carbon fiber reinforced polymer drilling with improved cutting mechanism

Experimental evaluation and modelling of drilling responses in CFRP/honeycomb composite sandwich panels

Drill-milling process and novel drill-milling tool for making a hole on carbon fiber–reinforced plastics

Effects of Specialized Drill Bits on Hoe Defects of CFRP Laminates

An Investigation of Drilling High-Strength CFRP Composites Using Specialized Drills

Tool life evaluation of CFRP drilling with three kinds of drill

Proposal of a tilted helical milling technique for high quality hole drilling of CFRP: kinetic analysis of hole formation and material removal

3D micromechanical modeling of orthogonal hole saw cutting on CFRP composites

Design of internal-chip-removal drill for CFRP drilling and study of influencing factors of drilling quality

Experimental investigation on mechanical drilling of a newly developed CFRP/Al co-cured material

Experimental characterization and finite element modeling of critical thrust force in cfrp drilling

Wear Behavior of Special Tools in the Drilling of CFRP Composite Laminates

Experimental Investigation on the Tilt Helical Milling of Carbon Fiber Reinforced Plastics (CFRP)

Optimization of CFRP drilling process: a review

Optimized selection of process parameters based on reasonable control of axial force and hole-exit temperature in drilling of CFRP

Investigation of CFRP cutting mechanism variation and the induced effects on cutting response and damage distribution

Machinability Of Drilling T700/Lt-03a Carbon Fiber Reinforced Plastic (Cfrp) Composite Laminates Using Candle Stick Drill And Multi-Facet Drill