Abstract:The new developed metal/composite co-cured material composed of carbon fiber–reinforced plastic and Al phases has been increasingly applied for manufacturing of attitude control flywheel in aerospace industry. However, drilling of co-cured material is still a challenging task to produce holes with high quality and low cost in the assembly chain and dynamic balance debugging of attitude control flywheel. In other words, the relevant mechanisms and experimental findings involved in the drilling process of carbon fiber–reinforced plastic/Al co-cured material is not clearly defined, which impedes the progress of attitude control flywheel production. To this end, this article specially addresses the experimental studies on the drilling process of carbon fiber–reinforced plastic/Al co-cured material with standard TiAlN-coated cemented carbide twist drill. The significance of this work aims to reveal the regardful cutting responses of the hole characteristics and tool wear modes during the practical drilling process of co-cured material. A full factorial experiment including three levels of feed rate and four levels of cutting speed was performed. The hole diameter shows different values in different positions while it indicates consistent pattern regardless of the cutting variables: the largest in the Al phase, followed by the upper and lower carbon fiber–reinforced plastic phases, respectively. Grooves and matrix degradation are the major machining defects for carbon fiber–reinforced plastic layers, while a great chip debris adhered to the machined surface is the case for Al layer. Subsequent wear analysis showed that abrasion was mainly maintained at the vicinity of major/minor cutting edges and drill edge corner, followed by chip adhesion on the chisel edge region. Carbide substrate of drill flank face is exposed, and thereafter cavities are formed under the strong mechanical abrasion. These results could provide several implications for industrial manufacturers during the attitude control flywheel production.

A New Strategy of Carbon Fiber Reinforced Plastic Drilling Evaluation Using Thermal Measurement

On the Machining Temperature and Hole Quality of CFRP Laminates when Using Diamond-Coated Special Drills

In-situ temperature monitoring during rotary ultrasonic-assisted drilling of fiber-reinforced composites

Process of Drilling Carbon Fiber Reinforced Composite with Cemented Carbide Drill

Study of Thrust Force and Torque in Drilling Carbon Fibre Reinforced Plastics(cfrp) Using Twist Drill Brazed Diamond

Wear behaviour of CVD diamond-coated tools in the drilling of woven CFRP composites

Fabrication and Drilling Tests of Chemical Vapor Deposition Diamond Coated Drills in Machining Carbon Fiber Reinforced Plastics

Machinability Of Drilling T700/Lt-03a Carbon Fiber Reinforced Plastic (Cfrp) Composite Laminates Using Candle Stick Drill And Multi-Facet Drill

Drilling characteristics of carbon/epoxy and carbon/polyimide composites

Comparative Studies on the Effect of Pilot Drillings with Application to High-Speed Drilling of Carbon Fibre Reinforced Plastic (CFRP) Composites

Comparison of Cutting Forces and Cutting Temperatures of Two Drills in High Speed Drilling Carbon Fiber Composite

Drilling Force in High Speed Drilling Carbon Fibre Reinforced Plastics (CFRP) Using Half Core Drill

Researches on drilling CFRP (carbon fiber reinforced plastics) with diamond electroplated drill bit

Evaluation of Diamond-Coated Tools in Drilling High-Strength CFRP Composites

Improvement On The Cutting Performance Of Cvd Diamond Coated Drills In Drilling Cfrp

Combined Influences of Tool Shape and As-Deposited Diamond Film on Cutting Performance of Drills for CFRP Machining

Hole quality and tool wear when dry drilling of a new developed metal/composite co-cured material

High-speed drilling mechanism study of unidirectional CoCrFeNiAl fiber-reinforced aluminum matrix composites

Machining Responses of High-Strength Carbon/epoxy Composites Using Diamond-Coated Brad Spur Drills

Research of sintering diamond trepanning drilling Kevlar fiber reinforced composites

Study on the Drilling Process of the Carbon Fiber Composite Material