Abstract:CFRP (Carbon Fiber Reinforced Polymer) is widely used in the aerospace, automobile and construction industries. Its non-homogeneous and anisotropic nature often results in unfavorable hole quality during the drilling process, and exit delamination is a resulting phenomenon that has received much attention. Exit delamination occurs when the drilling thrust force exceeds the critical thrust force. It adversely affects product quality and may even result in rejection. The thrust force on the chisel edge is an important component of the total thrust force, and it helps to predict the total thrust force so that delamination can be reduced or avoided. In this study, noticing that the chisel edge has a certain length, the author puts forward the novel concept of the azimuth angle on the basis of the micro analysis of the contact state between the chisel edge and the carbon fiber. In addition to the orientation angle of the carbon fiber, the azimuth angle of the cutting edge is also an important factor that affects the thrust force. A single carbon fiber may be modeled as a beam on an elastic foundation, and the prediction model of thrust force on the chisel edge is established based on the theory of bending fracture. The model can reflect the influence of the material properties, cutting tool geometry parameters (including the length of chisel edge, rake angle and blunt radius of cutting edge), drilling process parameters, and ultrasonic vibration parameters on the thrust force on the chisel edge and quantitatively explain the reduction of thrust force and improvement of drilling quality during the longitudinal ultrasonic vibration drilling. The prediction model of the thrust force presented in this work can make up for the shortages of qualitative interpretation. The law of periodic variation of the chisel edge thrust force with the azimuth angle helps in developing a deep understanding of the CFRP drilling process and the material removal mechanism. The basis is provided in order to reduce and avoid the exit delamination defects in drilling, and to reasonably and quantitatively determine the spindle speed, feed rate, and drill bit geometry parameters. The reliability of the prediction model is verified by a drilling test.

Tool life evaluation of CFRP drilling with three kinds of drill

A New Strategy of Carbon Fiber Reinforced Plastic Drilling Evaluation Using Thermal Measurement

Study on Robot Automatic Drilling of Carbon Fiber Reinforced Plastics (CFRP)

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

Wear behaviour of CVD diamond-coated tools in the drilling of woven CFRP composites

Investigation of CFRP damages induced by the interface high temperature and mixed tool wear mechanism in drilling of thin-walled CFRP /Ti stacks

Mechanics of thrust force on chisel edge in carbon fiber reinforced polymer (CFRP) drilling based on bending failure theory

Combined analysis of wear mechanisms and delamination in CFRP drilling

Experimental Investigation of drill tool types on delamination error in drilling of CFRP

A semi-analytical model for predicting tool wear progression in drilling CFRP

Determination of the optimal feed rate for step drill bit drilling CFRP pipe based on exit damage analysis

Study on dedicated drill bit design for carbon fiber reinforced polymer drilling with improved cutting mechanism

Mechanical model for predicting thrust force with tool wear effects in drilling of unidirectional CFRP

Experimental evaluation and modelling of drilling responses in CFRP/honeycomb composite sandwich panels

A study on the ultrasonic vibration on the cutting performance during ultrasonic-assisted drilling of CFRP with twist and dagger drill bits

Optimization of CFRP drilling process: a review

Design of internal-chip-removal drill for CFRP drilling and study of influencing factors of drilling quality

Carbon fiber reinforced polymer in drilling: From damage mechanisms to suppression

A Study on Drilling High-Strength CFRP Laminates: Frictional Heat and Cutting Temperature

Analytical study of delamination damage and delamination-free drilling method of CFRP composite

Wear behaviors of PCD and diamond-coated tools during low-frequency vibration-assisted drilling CFRP/Ti stacks