Abstract:Reducing the vibration responses caused by the unbalance of the rotor is a crucial technology to ensure the safe and efficient operation of high-speed rotating machinery. For the flexible rotor system, the unbalance responses of rotors vary in different radial directions due to the anisotropic stiffness. The holospectrum technique using multi-sensor fusion provides ideas to solve this issue. The standard balancing method based on the holospectrum technique takes the Initial Phase Vector (IPV) as the balancing object, which could not represent the unbalance of flexible rotors correctly. In addition, the operating speed of the flexible rotor is generally higher than the first critical speed (FCS), making it necessary to fulfill the balancing of the first two modal shapes respectively in two steps. The above-mentioned procedure is not only very dangerous but also requires a large number of test runs resulting in corresponding wastages. In order to solve the issues mentioned above, a synchronous holo-balancing method for flexible rotors based on the modified initial phase vector (MIPV) is developed in this paper. Firstly, to tackle the limitation of IPV, the concept of equivalent rotating frequency circle is presented and then the MIPV is proposed as a new balancing object. MIPV could linearly represent the unbalance of the flexible rotor and increase the accuracy of holo-balancing. Secondly, the synchronous holo-balancing method is carried out to achieve the balancing at the speed below the FCS, reducing the complexity and danger of test runs at high operating speeds. And the synchronous balancing procedures based on the MIPV are further summarized in detail. Finally, two experimental results with different operating speeds and probe installations validate the feasibility and effectiveness of the proposed method. Compared with other traditional balancing methods, the proposed method can minimize the residual vibration and achieve state-of-the-art performances.

Research on the Separating Method of Vibration Signals for the Dual-Rotor System with Little Speed Difference in the Rotating Machinery

Extraction Of Unbalance Signals From Miniature-Rotor Dynamic Balancing Machine

Rigid Rotor Dynamic Balancing by Two-Plane Correction with the Influence Coefficient Method

Rigid Rotor Dynamic Balancing with the Influence Coefficient Method

Dynamic Balancing of a Centrifuge: Application to a Dual-Rotor System with Very Little Speed Difference

Non-whole beat correlation method for the identification of an unbalance response of a dual-rotor system with a slight rotating speed difference

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

An Improved Whole-Machine Balancing Method Based on Double Auto-Correlation Measurement

Synchronization Identification Method for Unbalance of Dual-Rotor System

Unbalance Identification of Nonlinear Rotor System Based on Holospectrum Analysis

Research on the Field Dynamic Balancing Technology and Instrument for a High Speed Cantilever Rotor

Research and Development of Whole-Machine Balancing Instrument for High Speed Rotor

A New Transient Field Balancing Method of A Rotor System Based on Empirical Mode Decomposition

A Balancing Method for Multi-Disc Flexible Rotors without Trial Weights

A Synchronous Holo-Balancing Method for Flexible Rotors Based on the Modified Initial Phase Vector

Study on Dynamic Balance Weighting for Single-Disk Rotor System Based on Phase Difference Mapping

Development of DSP-based measurement system of balancing machines

A novel rotor dynamic balancing method based on blade tip clearance measurement without the once per revolution sensor

A New Dynamic Balance Framework Based on Blind Source Separation under Multiple Fault Conditions

Research on Field Balancing of Rotor