Abstract:The undesired synchronous vibration due to rotor mass imbalance is a main disturbance source in all rotating machinery including active magnetic bearing (AMB)-rotor systems. In the AMB-rotor system, imbalance compensation, which causes the AMB actuators to spin a rotor about its geometric axis, and automation balancing, which spins a rotor about its inertial axis, are two kinds of common control aim for the rotor imbalance control. In this study, the internal relation between the imbalance compensation and the automation balancing is analyzed and a uniform control method is proposed. With the identical control algorithm, the proposed control method can realize the automation balancing or the imbalance compensation, respectively, by switching the controller's junction position in the original control loop. The proposed control method does not depend on the dynamic plant model, because its algorithm is based on the real-time identification for the Fourier coefficient of the rotor imbalance disturbance. In this paper, the process of identification algorithm is given in detail and all the possible junction forms of the controller are illustrated. By the simulations, the identification performances of the control algorithm are compared in the conditions with three variable factors, including the signal noise ratio (SNR), the imbalance phase and the identification delay time. The noise level has considerable influence on the identification precision, but the imbalance phase has little. To prolong the identification delay time will be of benefit to improve the identification precision but slow down the identification process. Experiments, which are carried out on an AMB-rigid rotor test rig, indicate that by switching the junction position of the controller in control loop, both kinds of rotor imbalance control can achieve the good effectiveness. [DOI: 10.1115/1.4005279]

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

Rigid Rotor Dynamic Balancing with the Influence Coefficient Method

Rigid Rotor Dynamic Balancing by Two-Plane Correction with the Influence Coefficient Method

Extraction Of Unbalance Signals From Miniature-Rotor Dynamic Balancing Machine

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Research on key technologies of automated balancing machines

Design and Implementation of Automatic Balancing Machine for Pump Impeller

Collaborative Simulation of Compound Dynamic Balancing Device for High-Speed Rotor System

Study of Automatic Dynamic Balancing System for Engine Crankshaft

Study on Calibration Method and System Error Compensation of Balancing Machines

The Study of an On-line Automatic Dynamic Balancing System and Its Dynamic Balancing Method when Used on a Flexible Rotor

On-line Unbalance Identification of Flexible Rotor System

Benchmark solutions for the dynamic analysis of general rotor-bearing system with arbitrary linear boundary conditions

Dynamic Balancing of a Centrifuge: Application to a Dual-Rotor System with Very Little Speed Difference

Research on the Field Dynamic Balancing Technology and Instrument for a High Speed Cantilever Rotor

Study on improving field first dynamic balancing precision of rigid rotors

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.

Analysis of Imbalance Calculation Method in Dynamic Balancing Machinery

A METHOD TO SELECT WEIGHTS IN ONLINE DYNAMIC BALANCE TECHNOLOGY BASED ON ROTOR-ACTIVE MAGNETIC BEARING SYSTEM

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

Auto balance of active magnetic bearings for rotor support system by means of unbalance identification