Abstract:Reducing the vibration responses caused by the unbalance of the rotor is a crucial technology to ensure the safe and efficient operation of high-speed rotating machinery. For the flexible rotor system, the unbalance responses of rotors vary in different radial directions due to the anisotropic stiffness. The holospectrum technique using multi-sensor fusion provides ideas to solve this issue. The standard balancing method based on the holospectrum technique takes the Initial Phase Vector (IPV) as the balancing object, which could not represent the unbalance of flexible rotors correctly. In addition, the operating speed of the flexible rotor is generally higher than the first critical speed (FCS), making it necessary to fulfill the balancing of the first two modal shapes respectively in two steps. The above-mentioned procedure is not only very dangerous but also requires a large number of test runs resulting in corresponding wastages. In order to solve the issues mentioned above, a synchronous holo-balancing method for flexible rotors based on the modified initial phase vector (MIPV) is developed in this paper. Firstly, to tackle the limitation of IPV, the concept of equivalent rotating frequency circle is presented and then the MIPV is proposed as a new balancing object. MIPV could linearly represent the unbalance of the flexible rotor and increase the accuracy of holo-balancing. Secondly, the synchronous holo-balancing method is carried out to achieve the balancing at the speed below the FCS, reducing the complexity and danger of test runs at high operating speeds. And the synchronous balancing procedures based on the MIPV are further summarized in detail. Finally, two experimental results with different operating speeds and probe installations validate the feasibility and effectiveness of the proposed method. Compared with other traditional balancing methods, the proposed method can minimize the residual vibration and achieve state-of-the-art performances.

Research on the Field Dynamic Balancing Technology and Instrument for a High Speed Cantilever Rotor

Rigid Rotor Dynamic Balancing by Two-Plane Correction with the Influence Coefficient Method

Rigid Rotor Dynamic Balancing with the Influence Coefficient Method

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

Extraction Of Unbalance Signals From Miniature-Rotor Dynamic Balancing Machine

Collaborative Simulation of Compound Dynamic Balancing Device for High-Speed Rotor System

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Research on key technologies of automated balancing machines

Dynamic Balancing of a Centrifuge: Application to a Dual-Rotor System with Very Little Speed Difference

Research and Development of Whole-Machine Balancing Instrument for High Speed Rotor

Design and Implementation of Automatic Balancing Machine for Pump Impeller

Application of Elastomer O-rings Damper in High Speed Spin Tester

The Study of an On-line Automatic Dynamic Balancing System and Its Dynamic Balancing Method when Used on a Flexible Rotor

On-line Unbalance Identification of Flexible Rotor System

Non-whole beat correlation method for the identification of an unbalance response of a dual-rotor system with a slight rotating speed difference

Research on Field Balancing of Rotor

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

A Synchronous Holo-Balancing Method for Flexible Rotors Based on the Modified Initial Phase Vector

On line balancing of high speed magnetic suspended flywheel system under force free control of imbalance

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System