Abstract:The undesired synchronous vibration due to rotor mass imbalance is a main disturbance source in all rotating machinery including active magnetic bearing (AMB)-rotor systems. In the AMB-rotor system, imbalance compensation, which causes the AMB actuators to spin a rotor about its geometric axis, and automation balancing, which spins a rotor about its inertial axis, are two kinds of common control aim for the rotor imbalance control. In this study, the internal relation between the imbalance compensation and the automation balancing is analyzed and a uniform control method is proposed. With the identical control algorithm, the proposed control method can realize the automation balancing or the imbalance compensation, respectively, by switching the controller's junction position in the original control loop. The proposed control method does not depend on the dynamic plant model, because its algorithm is based on the real-time identification for the Fourier coefficient of the rotor imbalance disturbance. In this paper, the process of identification algorithm is given in detail and all the possible junction forms of the controller are illustrated. By the simulations, the identification performances of the control algorithm are compared in the conditions with three variable factors, including the signal noise ratio (SNR), the imbalance phase and the identification delay time. The noise level has considerable influence on the identification precision, but the imbalance phase has little. To prolong the identification delay time will be of benefit to improve the identification precision but slow down the identification process. Experiments, which are carried out on an AMB-rigid rotor test rig, indicate that by switching the junction position of the controller in control loop, both kinds of rotor imbalance control can achieve the good effectiveness. [DOI: 10.1115/1.4005279]

Synchronization Identification Method for Unbalance of Dual-Rotor System

Non-whole beat correlation method for the identification of an unbalance response of a dual-rotor system with a slight rotating speed difference

Extraction Of Unbalance Signals From Miniature-Rotor Dynamic Balancing Machine

The Effect on Dish Centrifuge'dynamical Characteristic of the Unbalance Weight of Rotor

Rigid Rotor Dynamic Balancing with the Influence Coefficient Method

Rigid Rotor Dynamic Balancing by Two-Plane Correction with the Influence Coefficient Method

Dynamic Balancing of a Centrifuge: Application to a Dual-Rotor System with Very Little Speed Difference

The Design of Dynamic Balancing Machine Based on Finite Element Analysis

On-line Unbalance Identification of Flexible Rotor System

Unbalance Identification of Nonlinear Rotor System Based on Holospectrum Analysis

Auto balance of active magnetic bearings for rotor support system by means of unbalance identification

Unbalance Compensation by Recursive Seeking Unbalance Mass Position in Active Magnetic Bearing-Rotor System

A uniform control method for imbalance compensation and automation balancing in active magnetic bearing-rotor systems

On-line Identification Based Unbalance Vibration Control With Less Regard to Rotor Speed in Active Magnetic Bearings Supporting Rotor System

Research on the Separating Method of Vibration Signals for the Dual-Rotor System with Little Speed Difference in the Rotating Machinery

A new multi-disk shaft balancing method for rotating machinery using strain gauges

Experimental and numerical investigations on an unbalance identification method for full-size rotor system based on scaled model

An Improved Whole-Machine Balancing Method Based on Double Auto-Correlation Measurement

A novel rotor dynamic balancing method based on blade tip clearance measurement without the once per revolution sensor

Method of Balancing Horizontal Decanter Centrifuge Without Resolving Beat and Pick-up and Process of “beat” Signal

Unbalanced Feature Identification of Rotor System Based on Fused Cross‐Correlation Fast Fourier Transform