Abstract:A finite element program for three dimensional thermal-elastic-plastic analysis was developed. Because of the geometrical nonlinearity and the temperature dependent material nonlinearities during welding, it is an imprortant problem how to ensure the computing accuracy and to get the stable solution, especially at a high temperature stage. Factors that may influence the accuracy and the convergence of computation were investigated. The results show that the stages with drastic change, such as transition from elastic to plastic, unloading stage, and stage in which material properties vary rapidly with temperature, suffer from the numerical error. When the solid elements are used for the bending problem of a thin plate or a shell, numerical locking phenomenon may also influence the solution.Residual deformations were analyzed by the developed program for two models taken from shrinkage fit process and plug welding process of a compressor. In the program proper methods were introduced to improve the accuracy and the convergence of numerical analysis. One of them is to use weight factors for strain increment in the stages with drastic changes in mechanical status and material properties. In order to prevent the locking phenomenon, the selective reduced integration method was adopted to the cylinder part of the compressor. The calculated deformations were compared with the measured values. The results show that good agreement can be obtained after introducing the proposed methods and that the developed program can provide satisfactory solutions. The influences of the welding conditions upon the eccentricity of assembled components in the compressor were also investigated.

The Impact of Welding Sequence on the Deformation of Flanges for Large Welded Casing Split

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Welding deformation prediction and structure optimization of air conditioning compressor based on FEM

Prediction for Welding Deformation Reducing by Welding Sequence Optimization of Upper Plate

Welding Sequence in Large Thin-Walled Structures by Means of Local-Global and Welding Macro Element

Numerical Analysis on Optimizing Welding Sequence of Large-Sized Bottom Structure for Controlling Welding Distortion

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Numerical Simulation on Welding Behavior in Large-diameter Flange

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Development of Finite Element Program of Three Dimensional Thermal-Elastic-Plastic Analysis and Its Application to Assembly of a Compressor by Welding.

Numerical Simulation of Welding Deformation and Its Evolution for Welded Cylinder with Angle-inserting Elbow

Effect of welding on elephant foot buckling of large oil storage tank

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

A Comparative Study of the Residual Deformation of an Automotive Gear-Case Assembly Due to Deep-Penetration High-Energy Welding

Study on FEM Numerical Simulation Method for the Welding Distortion

Evaluation Method for Inherent Deformation and its Application in Predicting Welding Distortion on Hull Blocks

A review of welding simulation methods for large components

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Theoretical Prediction of Welding Distortion Considering Positioning And the Gap Between Parts

Dimensional precision controlling on out-of-plane welding distortion of major structures in fabrication of ultra large container ship with 20000TEU

A Study on the Effects of Welding Deformation According to Weld Sequence in Overlay-Welded Structures