Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Theoretical Prediction of Welding Distortion Considering Positioning And the Gap Between Parts

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Machining Distortion Prediction of Aerospace Monolithic Components

Local-global Method to Predict Distortion of Aircraft Panel Caused in Automated Riveting Process

Reverse Deformation Design for Bending Control in Welding of Ring Stiffeners

Study on FEM Numerical Simulation Method for the Welding Distortion

Recent Advances in the Prediction of Weld Residual Stress and Distortion - Part 1

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Numerical Prediction of Welding Distortion Considering Gravity Force on General Ship Grillage Structure by Elastic Finite Element Method Using Inherent Strain

Study on the Prediction of Welding Distortion of Aluminium Alloy Based on Inherent Strain Method

The Influence of Pre-existing Deformation on GMA Welding Distortion in Thin Steel Plates

Welding Distortion Prediction of Ship Plate Frame Structures Based on a Self-Learning Database

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Welding-induced stresses and distortion in high-strength steel T-joints: Numerical and experimental study

Prediction of Welding Deformation of Automotive Components Using Large-scale Thermal Elastic Plastic Analysis

Accuracy of computational welding mechanics methods for estimation of angular distortion and residual stresses

Finite Element Analysis on Welding-Induced Distortion of Automotive Rear Chassis Component