Abstract:Based on the mechanism that theodolite leads to a moving line, a new method of measuring the perpendicularity of guideway was presented. Firstly, a theodolite is installed on the horizontal linear moving base of Y guideway and a crosshair target is fixed on the foundation. When the theodolite is on different positions and pointed to the target as the level guideway is moving, the horizontal angles of the target are acquired. So two horizontal angles of the theodolite can be computed using least square method twice when the two collimation axis lines of the theodolite are parallel to the moving lines of X and Y guideways respectively, then the perpendicularity between X and Y guideways is calculated. After that, the theodolite is fixed on the foundation, the slight vertical angle changes of the target fixed on the horizontal linear moving guideway are observed, and the levelness errors of X and Y guideways are fitted respectively using least square method. Later on, the horizontal angle changes of the target fixed on the vertical Z guideway are measured with the theodolite, and the 2-D plumb errors of the Z guideway are achieved also using least square method. Finally, all the X-Y, Y-Z, Z-X three guideway perpendicularities are obtained, and the measurement error analysis is conducted. This method was applied in adjusting and measuring the perpendicularities of a lunar soft landing simulation system. Results show that this method can meet the requirement of the measurement accuracy.

Flatness and Parallelism Measurement Method of Two Circular Guideways

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

Development of Equipment for Simultaneously Measuring Two-dimensional Rotation Angles of the Linear Guide Track

Survey of rolling angle measurement methods

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

A Novel Method to Simultaneously Measure the Straightness

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Development of a simple system for simultaneously measuring 6DOF geometric motion errors of a linear guide.

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Measuring Error Correction Method During Deflection Measurement Process of the Regular Hexagon Section Shaft Based on Lever-Type Measuring Mechanism

Perpendicularity measurement method of 3-D large guideway with theodolite

A Geometric Error Measurement System for Linear Guideway Assembly and Calibration

A Method for Measuring the Guideway Straightness Error Based on Polarized Interference Principle

Full-scale Measurement of CNC Machine Tools

Study on the Method of High Accuracy Flatness Measurement

Development of a machine for automatically measuring static/dynamic running parallelism in linear guideways

A Stereovision-Based Efficient Measurement Approach for Surface Flatness of Concrete Members

Traversal Searching Algorithm of Flatness Error

Measuring Parallelism for Two Thin Parallel Beams Based on Autocollimation Principle

Online Measurement on Flatness and Its Uncertainty of Small Work-piece