Abstract:In this paper, an optimized process for preparation of photosensitive nanosilica from rice husk (RH) is described. The rice husk sample was pretreated by soaking in deionized water to remove most of the alkali metals and partial fixed carbon. Most metal oxides, especially alkaline metal oxides and alkaline-earth metal oxides, were removed to a certain extent after the soaking pre-treatment. Soaking pretreatment may remove the hydrogen bonds or extractives between hemi-cellulose and cellulose, which affects the thermal stability of both molecules. To thoroughly analyze the soaking process, thermogravimetric analysis (TGA) was performed to obtain the mass loss behavior of soaked rice husk. The characteristics of the nanosilica prepared from the method described in this paper are superior to those of fumed silica. The silica content of the nanosilica reached a record of 99.92% in pyrolysis method. The optimum preparation conditions were as follows: a rice husk feedstock particle size of between 250 and 420 mu m, a pyrolysis temperature of approximately 610 degrees C, a hydrolysis temperature of 120 degrees C, a 1:10 (g/ml) ratio of rice husk to acid, a hydrolysis time of 4 h, and a hydrochloric acid (HCI) concentration of 8% (wt.%). A detailed study of the effects of the pyrolysis temperature and feedstock particle size was conducted, filling the gap in systematic research on the nanosilica preparation process using the pyrolysis method. The complete process of pyrolysis for pretreated rice husk is described, including the decomposition of the major constituents, volatilization of gases and the formation of silica. The results of this study provide a deep understanding of nanosilica production by pyrolyzation. The prepared nanosilica is photosensitive and approximately spheroidal with an average particle size of approximately 8-10 nm. (C) 2013 Elsevier B.V. All rights reserved.

Preparation of Nanoporous Silicon and Study on Its Properties

PREPARATION OF NiO NANOPARTICLES ON THE SILICA SURFACE BY ADSORPTION PHASE SYNTHESIS AND ITS REGULATION ON MORPHOLOGY OF NiO PARTICLES

Studies on Preparation of Ag/SiO2 Nanocomposite and Its Electrical Properties

Synthesis of Ag/SiO2 nanocomposite material by adsorption phase nanoreactor technique

STUDY OF PREPARATION AND PROPERTIES OF NANO-SCALE AgI- POROUS SiO2 COMPOSITES

Preparation of highly dispersed nanosilica from rice husk by aprecipitation method combined with high pressure homogenization

Preparation and Photoluminescence of Nanocrystalline Si-Rich Silicon Oxide Films by Pecvd

Preparation of Porous Composite Materials through Silicon Component Foaming and Special Heat Treatment

Study of Optical Properties of Porous Silicon Produced by Metal-Aid

Preparation of Mesoporous Si Nanoparticles by Magnesiothermic Reduction for the Enhanced Reactivity

Preparation of Methyltrimethoxysilane Derived Silica Aerogel Films via Ambient Pressure Drying

Study on preparation and surface modification of precipitated silica obtained from fly ash

Preparation Of Porous Silicon Using Anodizing And Suppercritical Drying

A Detailed Study of the Effects of Pyrolysis Temperature and Feedstock Particle Size on the Preparation of Nanosilica from Rice Husk

Preparation of Hierarchical Porous Silicon Carbide Monoliths via Ambient Pressure Drying Sol–Gel Process Followed by High-Temperature Pyrolysis

Preparation of porous silicon by vacuum sublimation dealloying method

Study on Fabrication and Thermal Analysis of Porous Silicon Nanoenergetic Materials

Progress in Preparation and Properties of Porous Silicon Nitride Ceramics

Preparation of Nano-Porous Carbon-Silica Composites and Its Adsorption Capacity to Volatile Organic Compounds

Hierarchical Porous Nanosilica Derived from Coal Gasification Fly Ash with Excellent CO2 Adsorption Performance

Preparation and Properties of Porous Silicon Carbide Ceramics Through Coat-Mix and Composite Additives Process