Abstract:Journal of Vibration and Control, Ahead of Print. During the firing process of a recoilless gun, there is a high-intensity pulse noise phenomenon in its rear breech area. In order to obtain the physical mechanism of the pulse noise formation, this article designed experiments and used high-speed cameras and overpressure sensors to discover a "three peaks" phenomenon in the pulse noise at the shooter's position. Using resistance strain sensors, the changes of strain with time in the chamber and nozzle expansion section of the recoilless gun during the firing process were recorded. By comparing the micro-strain data and overpressure data, the shock waves at the shooter's position can be categorized into two types: internal shock waves and external shock waves. Internally, the opening of the blocking sheet initiates the formation of the initial shock wave, followed by the formation of a second pressure wave within the combustion chamber. The peak-to-peak interval between these two shock waves is nearly fixed, and the ratio of the dual peaks increases with the distance of the measurement position. The third shock wave forms externally to the nozzle, induced by the explosion of unburned propellant. As the weapon's distance from the ground increases, the peak values of the overpressure data decrease, and the waveform of this explosion-induced shock wave transitions from a single-peak phenomenon to a double-peak phenomenon. This study can provide a reference for the study of the potential risk of injury to operators using single soldier recoilless guns and similar weapons.

Testing Technology for Pressure of Inner Chamber in Recoil Mechanism in Gun of Large-caliber

Research on Pressure Measurement System in Perforating Gun and Analysis of Test Data

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

Testing Machine for Testing Durability of Material under High-Pressure Hydrogen Circumstance

Design and Simulation Research on Tester of Perforator Cavity Pressure

The Miniature Internal Electronic Pressure Gauge and Dynamic Calibration Method

Numerical Simulation of the Two-phase Flow of a Constant-pressure Rear-spray Low Recoil Weapon with Two Chambers

Research on Pressure Measurement System in Perforation Gun

Research Progress of Pressure Testing Technology for Electrothermal-Chemical Launch

Environmental Factors Calibration Technology of Weapon Chamber Pressure Test System

Calibration Apparatus for Artillery Chamber Pressure Test Device Based on Environmental Factors

Research on the Recoil Dynamic Characteristic of Gun Tester Based on ABAQUS

Structural Strength Analysis of Special Dynamic Calibration Equipment for Artillery Chamber Pressure Testing System

Study on Micro Recoil Mechanism of the Weapon with a Nozzle and Two Chambers Separated by a Partition

Super-High Initial Velocity Mechanism of Bullet Propulsion with Adaptive Pressure-Maintaining Chamber

Research of Miniature Internal Electronic Piezo Gauge

Electrothermal-Chemical Gun Chamber Pressure Measurement System Based on Digital Optical Fiber Transmission

Design and simulation research on experimental equipment of gun recoil

Research on Projectile Breech Pressure Measuring Method Based on Storage Measurement Technique

Experimental study on the physical mechanism of pulse noise in the tail of a recoilless gun

The Strength Analysis the Body of on the Dynamic Calibration Device in Caunon Chamber Pressure Testing