Abstract:Direct measurement of the wall pressure loading subjected to the near-field underwater explosion is of great difficulty. In this article, an improved methodology and a lab-scale experimental system are proposed and manufactured to assess the wall pressure loading. In the methodology, a Hopkinson bar (HPB), used as the sensing element, is inserted through the hole drilled on the target plate and the bar’s end face lies flush with the loaded face of the target plate to detect and record the pressure loading. Furthermore, two improvements have been made on this methodology to measure the wall pressure loading from a near-field underwater explosion. The first one is some waterproof units added to make it suitable for the underwater environment. The second one is a hard rubber cylinder placed at the distal end, and a pair of ropes taped on the HPB is used to pull the HPB against the cylinder hard to ensure the HPB’s end face flushes with loaded face of the target plate during the bubble collapse. To validate the pressure measurement technique based on the HPB, an underwater explosion between two parallelly mounted circular target plates is used as the validating system. Based on the assumption that the shock wave pressure profiles at the two points on the two plates which are symmetrical to each other about the middle plane of symmetry are the same, it was found that the pressure obtained by the HPB was in excellent agreement with pressure transducer measurements, thus validating the proposed technique. To verify the capability of this improved methodology and experimental system, a series of minicharge underwater explosion experiments are conducted. From the recorded pressure-time profiles coupled with the underwater explosion evolution images captured by the HSV camera, the shock wave pressure loading and bubble-jet pressure loadings are captured in detail at 5 mm , 10 mm , ... , 30 mm stand-off distances. Part of the pressure loading of the experiment at 35 mm stand-off distance is recorded, which is still of great help and significance for engineers. Especially, the peak pressure of the shock wave is captured.

Research of Miniature Internal Electronic Piezo Gauge

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

Extra-high Pressure Pneumatic Test Bed Based on Virtual Instruments

Design and Research of Ultra-Miniature Pressure Sensors

Modeling of Ammunition Dynamic Pressure Measurement Chain in Ballistic Tests

Research on Micromachined Pirani Gauge

Research on Micro Vacuum Measurement Device Based on Heat Transfer Principle

Non-Destructive Gas Pressure Measurement in Compact Sealed Electronic Vacuum Devices by Penning-Type Discharge

Design, Fabrication, and Dynamic Environmental Test of a Piezoresistive Pressure Sensor

A Lab-Scale Experiment Approach to the Measurement of Wall Pressure from Near-Field under Water Explosions by a Hopkinson Bar

An Ultra-High Pressure Sensor Based on SOI Piezoresistive Material

The Design and Optimization of a Highly Sensitive and Overload-Resistant Piezoresistive Pressure Sensor.

Design of Piezoelectric Pressure Transducer and Its Application in Dynamic Balancing Measurement System

Research on Miniature In-pipe Robot Driven by Piezoelectric Force

Piezo-resistance Diamond Pressure Microsensor

Analytical and experimental study of a valveless piezoelectric micropump with high flowrate and pressure load

Application of tiny acceleration testing apparatus on the gatling weapon

A Study of Impact Piezoelectric Property of PVDF Stress Gauges

Design and fabrication of a tiny micro-pressure sensor with improved linearity and sensitivity

Research Progress of Pressure Testing Technology for Electrothermal-Chemical Launch