Abstract:In this paper, a unified equivalent circuitmodel which can simplify the design and analysis of a family of high-voltage (HV) generation architectures based on the series-parallel (LCC) resonant converter is proposed. First, four HV generation architectures are reviewed in terms of the modularization level of HV transformers and rectifiers. Next, the steady-state, unified equivalent resistor and capacitor (RC) model that can be easily embedded into the resonant tank to replace the complex HV transformers and rectifiers is derived. The generic model can be applied to the HV generators with different architectures, different voltage multiplier topologies, stage, and polarities number. Further analysis of the power factor of the resonant tank, the voltage gain of HV generators, and electrical stresses of power components is achieved with the derived equivalent circuit model. The analysis reveals the inherent circuit properties among HV generators with different configurations. Subsequently, a comprehensive design methodology considering the power factor, conduction angle, and quality factor is presented, which leads to low electrical stresses on the components and high efficiency. Furthermore, the parameter selection constraint based on the power factor, conduction angle, and quality factor is derived, which can ensure the effective design outputs. Finally, the proposed unified equivalent model and comprehensive design methodology are validated by the experimental results of a 250 V input, 20 kV output 500 W HV generator hardware prototype with distributed transformers and voltage multipliers.

Steady-state Modeling of Controllable Shunt Reactor of Transformer Type

Synthesis Load Model with Ideal Transformer

A Voltage Control Model of Multi-ports DC Transformer

Current Saturation Analysis and Anti-Windup Control Design of Grid-Forming Voltage Source Converter

Impedance-based Analysis of Constant Reactive Power Control for Voltage Source Converter in Weak AC Grids

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Unified Equivalent Steady-State Circuit Model and Comprehensive Design of the LCC Resonant Converter for HV Generation Architectures

Feasibility Research on Controlled Rectifier Type of Static Var Compensator

Research on the Characteristics of a High-temperature Superconducting Leakage Flux-controlled Reactor

A Novel Continuously Adjustable Magnetic-valve Controllable Reactor and Its Modeling

Transient model for VSC-HVDC and its control design

Control strategy of transformer coupling solid state fault current limiter and its experimental study with capacitance load

Steady-state Analysis of Internal Short Circuits of Multi-winding Power Transformer Part Ⅰ Modeling and Simulations

Transient modeling and switching logic analysis of a power-electronic-assisted OLTC based Sen transformer

Modeling, Simulation and Control Strategy of a Novel 10 Kv 15-Level M-STATCOM under SVG Condition

On switching transient modeling and analysis of electronic on-load tap-changers based Sen transformer

Control Sheme of Novel Solid State Transformer Based on Virtual Synchronous Generator

STEADY STATE STUDY OF ±50 Mvar STATCOM WITH CHAIN-CIRCUIT TOPOLOGY