Abstract:When fault occurs on cross-coupling autotransformer (AT) power supply traction network, the up-line and down-line feeder circuit breakers in the traction substation trip at the same time without selectivity, which leads to an extended power failure. Based on equivalent circuit and Kirchhoff's current law, the feeder current characteristic in the substation, AT station and sectioning post when T–R fault, F–R fault, and T–F fault occur are analyzed and their expressions are obtained. When the traction power supply system is equipped with wide-area protection measurement and control system, the feeder protection device in each station collects the feeder currents in other two stations through the wide-area protection channel and a wide-area current differential protection scheme based on the feeder current characteristic is proposed. When a short-circuit fault occurs in the power supply arm, all the feeder protection devices in each station receive the feeder currents with time stamp in other two stations. After data synchronous processing and logic judgment, the fault line of the power supply arm can be identified and isolated quickly. The simulation result based on MATLAB/Simulink shows that the power supply arm protection scheme based on wide-area current differential has good fault discrimination ability under different fault positions, transition resistances, and fault types. The verification of measured data shows that the novel protection scheme will not be affected by the special working conditions of the electrical multiple unit (EMU), and reliability, selectivity, and rapidity of relay protection are all improved.

Polarity Comparison Fast Bus Protection for Asynchronous Sampling Fault Current

A Fast Bus Bar Protection Based on Fault Superimposed Current Polarity Comparison

Instantaneous Impedance-Based Bus-Bar Protection Principle

Study on the differential protection of busbar with magnetic restraint

MAGNETIC RESTRAINING DIFFERENTIAL BUS PROTECT

Fast Fault Protection Based on Direction of Fault Current for the High-Surety Power Supply System

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

An Instantaneous Equivalent Impedance Based Bus-bar Protection Technique

A fast fault protection based on direction of bus-side capacitor discharge current for a high-surety power supply

Equivalent Instantaneous Impedance Based Bus-Bar Protection

Integrated Protection Of Distribution Lines Using Transient Comparison Technique

A Blocking Method for Bus Protection of CT Disconnection and Opening Method of HIF Based on Current Characteristics

A novel principle dispensing with data synchronization for distributed bus protection

Transient Polarity Comparison for Integrated Protection of Distribution Network

A novel busbar protection scheme based on wavelet multi-resolution signal decomposition

STUDY ON THE CURRENT TRAVELING-WAVE DIFFERENTIAL BUS PROTECTION

Protection of Transmission Systems Using Transient Polarity Comparison Technique

A Positional Polarity Comparison Relay Utilizing Global Positioning System

Power supply arm protection scheme of high-speed railway based on wide-area current differential

Centralised Busbar Differential and Wavelet‐based Line Protection System for Multi‐terminal Direct Current Grids, with Practical IEC‐61869‐compliant Measurements

A Model Parameter Identification Based Bus-bar Protection Principle