Study onFault Location Method Based on Leakage Energy Function

Zilong LI,Tao LIU,Shengqiang HUANG,Gehao SHENG,Xiuchen JIANG

DOI: https://doi.org/10.3969/j.issn.1673-7598.2017.07.017

2017-01-01

Abstract:The traditional distribution network fault location method only uses the data after the failure,while ignoring the use of pre-fault information. At the same time,most of the location methods only consider the zero sequence current information(the need for three-phase information)with high transformer requirements and complex information access. So these methods will fail in the absence of some data. This paper relies on the fastness and reliability of the measured data under the wide area measurement system to make full use of the fault phase voltage and current data of the whole process of fault occurrence and arc suppression coil action ,and does not need to use the zero sequence current which is difficult to measure. The fault location method of distribution network based on the leak?age energy function is proposed. Simulation results under PSCAD show that this method improves the sensitivity ,reliability of ground fault location and has high sensitivity when grounded with high impedance. Besides,the method uses only single-phase data to avoid the use of phase modeling and other mathematical methods to decouple the three-phase line, reduce the effect of lacking measurement device phase to the minimum.