Abstract:Dielectric loss factor measurement is an important index in accessing the insulation performance of power equipment. With the development of the condition-based maintenance and smart grid, more attention has been paid to online diagnostic technologies for the dielectric loss factor measurement. Various methods have been developed in this field in which harmonic analysis (HA) is prevalent due to its performance of resisting disturbance and stability superior to others. When performing the HA method on the sampled data, the non-simultaneous sampling and the lack of synchronization between sampling rate and the signal period are believed to be the main source of error in the measurement of the magnitude and the phase of the signals. To improve the effectiveness of the HA method, measures were taken by means of the designing online monitoring system. The basic principle of the HA method is presented in this paper and an online monitoring system based on DSP technology is developed accordingly. At last, this paper analyses the on-line monitoring results resulted from the online monitoring system on a substation. To ensure the safe and reliable operation of a power system it is necessary to monitor periodically the insulation condition of HV apparatus. This may be accomplished through measuring partial discharge levels, dielectric loss factor and capacitance using conventional well-established time based maintenance method. To implement these routine tests require removal of equipment from service, however, the measure and continuous monitor may be carried out directly if on-line monitoring method is adopted. These on-line dielectric loss factor measuring methods detect the current flowing through the test object and the voltage signal applied to it. The various techniques reported in the literature differ from each other in the manner how the signals are acquired and how the gathered data are handled. In the work reported in this paper a distributed on-line monitoring system has been developed based on

Testing Technology of Multi-harmonic Characteristic Parameters and Its Application for UHVDC Dry-type Smoothing Reactors

Simulation On Power Characteristic Of Uhvdc During Commutation Failure And Dc Block

The Analysis of UHV Transmission’s Impact on Steam Turbine Operation

Method for Accurately Measuring the Power-Frequency Parameters of Ehv/Uhv Transmission Lines

Analysis of Characteristic Harmonics in ±800 Kv Ultra High Voltage Direct Current Power Transmission System

Study on Electric Field Distribution and Switching Impulse Discharge Characteristics of ±1100kv Dry-Type Smoothing Reactor

Study and design of main circuit parameters for ±800 kv/7500 MW DC power transmission project from Xiluodu to Zhexi

The Inner Voltage Component Analysis and Testing System for Converter Transformer Valve Side Bushings

Study on Equivalent Current Test Method of Noise of Dry-type Air-core Reactor

Dielectric Loss Factor Measurement of High Voltage Capacitive Apparatus Based on Harmonic Analysis Method

Study On Inter-Harmonics In Short-Circuit Current Of Hybrid Ac/Dc Electric Power Systems

Influence of Smoothing Reacteor Arrangement on Transients of Converter Station for &#x00b1;500kv Double-Circuit HVDC System

Study on Harmonic Current Amplification Characteristics of HVDC Transmission Lines

Simulation and Experiment on Discharge Characteristics of Indoor Devices in ±1100 Kv Converter Station Based on Potential Gradient Equivalent Method

Equivalent Modeling and Real Parameter Measurement Methods of Control Systems of UHVDC Transmission Systems

Operating State Evaluation Method of UHV Oil Immersed Shunt Reactors

Study on the Nonlinear Vibration Characteristic of Dry-Type Air-Core Reactor

Harmonic Analysis Study for High-voltage Distribution Equipment on Power Factor

Analysis and Mitigation of Low-Frequency Resonance in a Long-Distance UHVDC ±1100 Kv System

Fast Calculation of Converter Characteristic Harmonic Currents with Time Domain Piecewise Method

Research on the dynamic characteristics of electric field distribution of the ± 1100 kV Ultra high voltage converter transformer valve‐side bushing using weakly ionised gas conductance model