Abstract:The series resonance type fault current limiter has the advantages of simple operating principle and topological structure,etc. The primary parameter of series resonance type fault current limiter for high-voltage system is reasonable.However,in the process of restraining fault current after a fault occurrence in electrical network,the capacitor and parallel inverter switch will confront poor working condition.This paper studies the above condition by simulation using the software Matlab.Proceeding from the study,we arrive at the conclusions:1)in the process of closing the inverter switch short circuit capacitor to make the current limiter work in short circuit current limiting mode switching from normal operation mode,there is higher-order of voltage(current)oscillation between capacitor and parallel inverter switch,and the peak value of voltage(current)increases and oscillates with the growing of the speed for closing the inverter switch; 2)when the inverter switch is composed of semiconductor device,control system must respond to short circuit and close the inverter switch quickly,otherwise,the semiconductor device may be damaged by over current(voltage);3)during fault current limiter working in current limiting mode to short circuit loop being shut off by relay protection device,the inverter switch will bear the full fault current and oscillation current.If using semiconductor device as inverter switch,the capacity of semiconductor device must be chosen according to the working condition.

Inverse Time-Limited Overcurrent Protection Technology for Solid State Power Controller Based on FPGA

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

Experimental Study on the Solid-state Fault Current Limiter with Bypass Inductance

Design And Test Of Unified Power Flow Controller Protection Circuits

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

Fast-transient repetitive controller based current control strategy for a cascaded DSTATCOM

An Improved Topology of Unified Power Flow Controller Based on MMC with Fault Current Limiting

Start-stop Control Strategy for UPFC with Fault Current Limiting

Multiobjective Fault-Tolerant Control for Fuzzy Switched Systems with Persistent Dwell Time and Its Application in Electric Circuits

Simulation Study of Series Resonance Type Fault Current Limiter

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

Real-Time Simulation of Power Electronic Systems Based on Predictive Behavior

Parameter design and optimization of unified power flow controller with fault current limiting

Study on Mathematic Model and Model Simulation of the Three Phase Solid State Fault Current Limiter

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

Parameters Design and Example of Unified Power Flow Controller with Fault Current Limiting

Application of FPGA in High-Power Multiphase Variable Speed Drives

A High Speed Short-Circuit Protection Circuit with Current Limitation and Soft Turn-Off for High Power IGBTs

Design and Test of UPFC-FCL Prototype.

Microprocessor-based Inverse Time Over-Current Protection Algorithm