Abstract:The series resonance type fault current limiter has the advantages of simple operating principle and topological structure,etc. The primary parameter of series resonance type fault current limiter for high-voltage system is reasonable.However,in the process of restraining fault current after a fault occurrence in electrical network,the capacitor and parallel inverter switch will confront poor working condition.This paper studies the above condition by simulation using the software Matlab.Proceeding from the study,we arrive at the conclusions:1)in the process of closing the inverter switch short circuit capacitor to make the current limiter work in short circuit current limiting mode switching from normal operation mode,there is higher-order of voltage(current)oscillation between capacitor and parallel inverter switch,and the peak value of voltage(current)increases and oscillates with the growing of the speed for closing the inverter switch; 2)when the inverter switch is composed of semiconductor device,control system must respond to short circuit and close the inverter switch quickly,otherwise,the semiconductor device may be damaged by over current(voltage);3)during fault current limiter working in current limiting mode to short circuit loop being shut off by relay protection device,the inverter switch will bear the full fault current and oscillation current.If using semiconductor device as inverter switch,the capacity of semiconductor device must be chosen according to the working condition.

Study on Mathematic Model and Model Simulation of the Three Phase Solid State Fault Current Limiter

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

Study on Control Strategy of the Three Phase Solid State Fault Current Limiter with Parallel Connected Inductance

Simulation Study of New Solid-State Fault Current Limiter

Experimental Study on the Solid-state Fault Current Limiter with Bypass Inductance

A Novel Six-Leg Three-Phase Fault Current Limiter

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

STUDY ON A NOVEL SOLID STATE FAULT CURRENT LIMITER WITH BYPASS REACTOR

Control Strategy & Test Study Of Ssfcl With Bi-Directional Current

Research of fault-current limiter for three-phase four-wire power system

Simulation study on a new solid state fault current limiter for high-voltage power systems

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

Simulation Study of Series Resonance Type Fault Current Limiter

Control strategy of transformer coupling solid state fault current limiter and its experimental study with capacitance load

Hybrid Multifunctional Saturated-core Fault Current Limiter

An Economical Three-Phase Fault Current Limiter Considering Different Types of Fault

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

A NOVEL TOPOLOGY OF SOLID STATE FAULT CURRENT LIMITER AND ITS CONTROL STRATEGY

A New Proposal for Solid State Fault Current Limiter and Its Control Strategies