Abstract:Fast linear transformer drivers (FLTDs) are a popular and potential route for high-power devices employing multiple “bricks” in series and parallel, but they put extremely stringent demands on gas switches. Electrode erosion of FLTD gas switches is a restrictive and unavoidable factor that degrades performance and limits stability. In this paper, we systematically investigated the electrode erosion characteristics of a three-electrode field distortion gas switch under the typical working conditions of FLTD switches, and the discharge current was 7–46 kA with 46–300 ns rise time. A high speed frame camera and a spectrograph were used to capture the expansion process and the spectral emission of the spark channel was used to estimate the current density and the spark temperature, and then the energy fluxes and the external forces on the electrode surface were calculated. A tens of kilo-ampere nanosecond pulse could generate a 1011 W/m2 energy flux injection and 1.3–3.5 MPa external pressure on the electrode surface, resulting in a millimeter-sized erosion crater with the maximum peak height Rz reaching 100 μm magnitude. According to the morphological images by a laser scanning confocal microscope, the erosion crater of a FLTD switch contained three kinds of local morphologies, namely a center boiling region, an overflow region and a sputtering region. In addition, the crater size, the surface roughness, and the mass loss were highly dependent on the current amplitude and the transferred charge. We also observed Morphology Type I and Type II, respectively, with different pulse parameters, which had an obvious influence on surface roughness and mass loss. Finally, the quantitative relationship between the electrode mass loss and the pulse parameter was clarified. The transferred charge and the current amplitude were proved to be the main factors determining the electrode mass loss of a FLTD switch, and a least squares fitting expression for mass loss was also obtained.

Investigation Review on the Erosion of Electrodes under the Arc in Air

The Influence of Different Parameter on Electrode Erosion During Opening Process

Research on Arc Erosion Products on Silver-metal Oxide Contacts Materials

Analysis of Erosion Resistance of CuC Arcing Contacts Manufactured by Plasma Spraying Technology

Investigation of vacuum arc ignition characteristics and erosion morphology microstructure characteristics of CuCr55 electrode contact materials

Research on dynamic characteristics of arc under electrode relative motion

Dynamic variation of arc discharge during current-carrying sliding and its effect on directional erosion

Characterisation of surface morphology of high voltage DC relay contacts under arc erosion

Experimental research on the fault arc arcing process and electrode temperature distribution of a 220VAC power system

Electrode erosion properties of gas spark switches for fast linear transformer drivers

Review on the Research Progress of Arc Plasma Power Sources in China

Influence of fabrication technology on arc erosion of Ag/10SnO2 electrical contact materials

Study of the Material Transfer Characteristics and Surface Morphology Due to Arc Erosion of PtIr Contact Materials

Arc stability and ablation characteristics in O2, N2, and air environments

Failure Analysis of Arc Ablated Tungsten-Copper Electrical Contacts

A review: Research on corrosive sulphur in electrical power equipment

Research on Corrosion Causes of Common Metal Material in Power Grid

The Influence of Electron Emission from the Electrode Materials on the Arcing Current in Inclined-plane Test

Chromium, a Promising Cathode Candidate for Homogeneous Arc Erosion in Air

Review on Soil Corrosion and Protection of Grounding Grids

Influence of Operation Numbers on Arc Erosion of Ag/CdO Electrical Contact Materials