Abstract:CuCr30 composite was commonly applied in medium and low voltage vacuum interrupters. The WC/CuCr30 composites based on changing of Cr particle morphology and orientation were successfully prepared by vacuum hot press sintering and hot extrusion, and the arc erosion resistance behavior at different voltages along the deformation direction of Cr particles was investigated on the JF04C electrical contact material testing system. The microstructure characterization of WC/CuCr30 composites shows that the Cr particles in the WC/CuCr30 composite have been elongated and the long axis direction is close to parallel to the extrusion direction after the hot extrusion deformation. Compared with the longitudinal section, the thermal conductivity of CuCr30 and WC/CuCr30 composites in the cross section is increases by 4.96% and 3.4%, respectively. The electrical contact testing results under different voltages shows that the addition of WC particles can extend the service life of the CuCr30 composite, and the operation times of WC/CuCr30 composite (4850 times) increases by 34.72% compared to CuCr30 composite (3600 times) at 30 V DC. The welding force decreases more obviously with the increase of the voltage, and the average welding force of WC/CuCr30 composite decreases by 8.57% and 20.9% at 18 V DC and 30 V DC compared with CuCr30, respectively. The arc erosion mechanism analysis shows that addition of WC particles is beneficial for the decrease of arc duration. And WC particles can effectively inhibit the arc erosion process and delay the formation of bumps and pits.

Failure Analysis of Arc Ablated Tungsten-Copper Electrical Contacts

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Arc ablation resistance behavior of Cu-W alloys with different W contents under atmospheric environment

Experimental and Numerical Simulations of ELM-like Transient Damage Behaviors to Different Grade Tungsten and Tungsten Alloys

Investigation of vacuum arc ignition characteristics and erosion morphology microstructure characteristics of CuCr55 electrode contact materials

Arcing Failure Analysis of Miniature Circuit Breaker Using Nano-W–cu Material

Study of microstructural evolution during operation of electrically connected components and analysis of failure mechanism

Phase-Field Simulation and Dendrite Evolution Analysis of Solidification Process for Cu-W Alloy Contact Materials under Arc Ablation

Cu–Y, Cu–La and Cu–Ba Alloys’ Microstructure and Ablation Behavior Discharging in Air and SF6

Influence of WC particles addition on material transfer behavior of CuCr30 contact material

Inhomogeneous Ablation Behaviors and Failure Mechanism of Copper Cathode in Air

Arc erosion resistance of WC/CuCr30 composites based on changing of Cr particle morphology and orientation

Characterisation of surface morphology of high voltage DC relay contacts under arc erosion

Thermal and arc erosion behavior of CuCr contact material based on large plastic deformation treatment

The Contact Resistance And Arc Erosion Behavior Of Separable Cp-Nb-Cr/Cu-Cd Electrical Contact Material

Analysis and Optimization of Contact Material Ablation under the Cumulative Effect of the Number of Breakings of OLTC

Review of the recent Chinese research on the electrical properties of CuCr contacts for vacuum interrupters

Corrosion behavior and mechanism of Cu/Ti3AlC2 composites under arc discharge in different atmospheres

Study on Current-Carrying Tribological Characteristics of C-Cu Sliding Electric Contacts under Different Water Content

Comparative Investigation into the Friction and Wear Behaviours of a Cu–Ag Contact Wire/carbon Strip and a Pure Copper Contact Wire/carbon Strip at High Speeds

Effect of the Vibration on Friction and Wear Behavior Between the Carbon Strip and Copper Contact Wire Pair