Abstract:To address the memory wall challenge, on-chip memory stacking has been proposed as a promising solution. The stacking memory adopts three-dimensional (3D) IC technology, which leverages through-silicon-vias (TSVs) to connect layers, to dramatically reduce the access latency and improve the bandwidth without the constraint of I/O pins. To demonstrate the feasibility of 3D memory stacking, this paper introduces a customized 3D Double-Data-Rate (DDR) SDRAM controller design, which communicates with DRAM layers by TSVs. In addition, we propose a parallel access policy to further improve the performance. The 3D DDR controller is integrated in a 3D stacking System-on-Chip (SoC) architecture, where a high-bandwidth 3D DRAM chip is stacked on the top. The 3D SoC is divided into two logic layers with each having an area of 2.5 x 5.0mm(2), with a 3-layer 2Gb DRAM stacking. The whole chip has been fabricated in Chartered 130nm low-power process and Tezzaron's 3D bonding technology. The simulation result shows that the on-chip DRAM controller can run as fast as 133MHz and provide 4.25GB/s data bandwidth in a single channel and 8.5GB/s with parallel access policy. (1)

Physical Design of 2 133 Mb/s DDR3 Memory Interface

Design of the DDR SDRAM Controller Integrated by the Data Intensive Computing Architecture

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

SDRAM Interface Design for Video Processing Algorithm

Reconfigurable Memory Bus Systems Using Multi-Gbps/pin CDMA I/O Transceivers.

Design and Implementation of DDR3 SDRAM Controller

Reconfigurable Memory Bus Systems Using Multi-Gbps/Pin Cdma 1/0 Transceivers

A Novel 1.8 V, 1066 Mbps, DDR2, DFI-Compatible, Memory Interface

Design of DDR2 SDRAM Memory User Interface Based on FPGA

Design and Implementation of A Ddr3-Based Memory Controller

Co-Design of DDR3 System Based on Mixed Modeling

A Novel Design of High-speed Multi-port Memory Interface for Digital Signal Processor

Design of DDR3 protocol parsing logic based on FPGA

Memory Interface Design for Multi-processor

Challenges in implementing DDR3 memory interface on PCB systems: a methodology for interfacing DDR3 SDRAM DIMM to an FPGA

Implementing an all-digital PHY and delay- locked loop for high-speed DDR2/3 memory interfaces

Design of DDR2 interface data acquisition based on Spartan-3A

A Design Of The Interface Between Dsp And Sdram

Timing Analysis and Design for DDR3 System

A Design of DSP External Memory Interface

A Customized Design Of Dram Controller For On-Chip 3d Dram Stacking