Abstract:DRAM is the dominant main memory technology used in modern computing systems. Computing systems implement a memory controller that interfaces with DRAM via DRAM commands. DRAM executes the given commands using internal components (e.g., access transistors, sense amplifiers) that are orchestrated by DRAM internal timings, which are fixed foreach DRAM command. Unfortunately, the use of fixed internal timings limits the types of operations that DRAM can perform and hinders the implementation of new functionalities and custom mechanisms that improve DRAM reliability, performance and energy. To overcome these limitations, we propose enabling programmable DRAM internal timings for controlling in-DRAM components. To this end, we design CODIC, a new low-cost DRAM substrate that enables fine-grained control over four previously fixed internal DRAM timings that are key to many DRAM operations. We implement CODIC with only minimal changes to the DRAM chip and the DDRx interface. To demonstrate the potential of CODIC, we propose two new CODIC-based security mechanisms that outperform state-of-the-art mechanisms in several ways: (1) a new DRAM Physical Unclonable Function (PUF) that is more robust and has significantly higher throughput than state-of-the-art DRAM PUFs, and (2) the first cold boot attack prevention mechanism that does not introduce any performance or energy overheads at runtime.

Implementing an all-digital PHY and delay- locked loop for high-speed DDR2/3 memory interfaces

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

Design of monolithic Phase-Locked Loop circuit for high-speed serial data link

A Novel 1.8 V, 1066 Mbps, DDR2, DFI-Compatible, Memory Interface

Design of the DDR SDRAM Controller Integrated by the Data Intensive Computing Architecture

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

Challenges in implementing DDR3 memory interface on PCB systems: a methodology for interfacing DDR3 SDRAM DIMM to an FPGA

Hardware Implementation of a High Performance and Low Power DDR2 Controller

Design and Implementation of DDR3 SDRAM Controller

High-speed DRAM architecture development

A Digital-Optical System-on-package Module Architecture for High Performance Multiprocessors

A low-power, area-efficient all-digital delay-locked loop for DDR3 SDRAM controller

A Controller PHY for Managed DRAM Solution With Damping-Resistor-Aided Pulse-Based Feed-Forward Equalizer

Design and Implementation of an AHB-based High-Speed Memory Access Layer

A Radiation-Hardened Dll With Fine Resolution And Dcc For Ddr2 Memory Interface In 0.13 Mu M Cmos

A Customized Design Of Dram Controller For On-Chip 3d Dram Stacking

Design of Dual-Shared Dram Controller Based on Switch

Distributed memory interface synthesis for network-on-chips with 3D-stacked DRAMs

An eDRAM with Logic Technology Using High-Speed R/W and Compact Charge Transfer Refresh Scheme

CODIC: A Low-Cost Substrate for Enabling Custom In-DRAM Functionalities and Optimizations

Design of an Embedded High Speed Dual-Port SRAM in Display Control/Driver ICs