Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

The Comb Electrode Dual-Axis Micromachined Accelerometer

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design of dual-axis micromachined accelerometer

A Novel Capacitive Accelerometer with A Highly Symmetrical Double-Sided Beam-Mass Structure

Micromachined Tri-Axis Capacitive Accelerometer Based on the Single Mass

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

A micromachined resonant accelerometer

A Novel Z-Axis Capacitance Accelerometer with Highly Symmetrical 16-Beam Structure

A Biaxial Capacitive Microaccelerometer with A Single Proof-Mass

A New Symmetrical Beam-Mass Structure for Accelerometers by Anisotropic Etching Without Convex Corner Compensation

Design and Simulation of A Multi-Finger Micromechanical Silicon Accelerometer

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

A Micromachined Silicon-on-Glass Accelerometer with an Optimized Comb Finger Gap Arrangement

Fabrication and Test of a Capacitive Biaxial Microaccelerometer

Design, Fabrication, and Characterization of a High-Performance Monolithic Triaxial Piezoresistive High-g Accelerometer

A High-Performance Monolithic Triaxial High-G Accelerometer

A CMOS Z-Axis Capacitive Accelerometer with Comb-Finger Sensing

High-Performance Single-Side Fabricated (111)-Silicon Dual-Cantilever Accelerometer with Squeeze-Film Air Damping Modulation

Structural Design and Testing of a Micromechanical Resonant Accelerometer

A Novel Biaxial Resonant Micro Accelerometer with Microleverage Mechanism