Abstract:Polyethersulfone (PES) hollow fiber ultrafiltration (UF) membranes were fabricated using methanol, ethanol, n-propanol as well as water as additives and N-methyl-2-pyrrolidone (NMP) as a solvent. Asymmetric hollow fiber UF membranes were spun by wet and dry/wet phase inversion method from 18wt.% solids of PES/non-solvent/NMP solutions. The non-solvents were methanol, ethanol, n-propanol and water while the external coagulant was water. Effects of non-solvent and ethanol concentrations in the dope solution and air-gap distance on morphology and separation performance of PES hollow fiber UF membranes were investigated. UF membranes were characterized in terms of their solubility parameter difference, pore size and pore density measurements, scanning electron microscope (SEM) while UF experiments were conducted using polyethylene glycol (PEG 10,000 MW) and two kinds of proteins, lysozyme (14,400 MW) and chicken egg albumin (CEA 45,000 MW) as a solute. It was found that the PES UF membrane morphology changed slowly from long and wide finger-like structure through a thin finger-like structure to the sponge-like structure with some voids as ethanol concentration in the dope solution increased from 0 to 25wt.% using 90:10 NMP/H2O as a bore fluid; pure water permeation fluxes (PWP) increased from 47 to 167L/(m2·h·bar) while rejections of PEG 10,000 and two protein for wet-spun PES hollow fiber membranes were increased within less than 10wt.% ethanol concentration and then decreased with an increase of ethanol concentration. Experimental results illustrated that PWP flux and solute rejection of the dry/wet-spun fibers were higher than that of the wet-spun fibers when 15wt.% ethanol and 15wt.% methanol were used as additives. PWP flux of PES hollow fibers using 25wt.% n-propanol and 7.5wt.% water (dry/wet) as additives in the dope solution were higher while their rejections were lower. In addition, the pore sizes of internal surfaces of PES hollow fiber membranes were controlled by adjusting the ethanol or methanol concentration in the dope solution. Using above method, PES hollow fiber UF membrane with high PWP could be prepared while the molecular weight cut-off of PES hollow fiber membranes is approximately 10,000.

Overview of Research Progress at Home on Development of Polyethersulfone(PES)Based Ultrafiltration Membrane

Preparation and Performance of Polyethersulfone Hollow-Fiber Membrane

Facile membrane preparation strategy to reinforce permeability of polyethersulfone (PES) micro-ultrafiltration membrane for drinking water treatment

Designing of a novel polyethersulfone (PES) ultrafiltration (UF) membrane with thermal stability and high fouling resistance using melamine-modified zirconium-based metal-organic framework (UiO-66-NH2/MOF)

Development of Polyethersulfone/α-Zirconium phosphate (PES/α-ZrP) flat-sheet nanocomposite ultrafiltration membranes

Effects of a dual functional filler, polyethersulfone-g-carboxymethyl chitosan@MWCNT, for enhanced antifouling and penetration performance of PES composite membranes

Preparation of Antifouling Ultrafiltration Membranes from Copolymers of Polysulfone and Zwitterionic Poly(arylene Ether Sulfone)s

Engineering High-Effective Antifouling Polyether Sulfone Membrane with P(Peg-Pdms-Kh570)@Sio2 Nanocomposite Via In-Situ Sol-Gel Process

Iron-tannin-framework complex modified PES ultrafiltration membranes with enhanced filtration performance and fouling resistance

Fabrication of an antifouling and acid/alkali‐resistant sulfonated polyethersulfone (S‐PES)/polysulfate (PSE) composite ultrafiltration membrane and its application in the desalination of ulinastatin

Construction of a composite microporous polyethylene membrane with enhanced fouling resistance for water treatment

Preparation and characterization of a polyethersulfone/polyaniline nanocomposite membrane for ultrafiltration and as a substrate for a gas separation membrane

Improved Protein Removal Performance of PES Hollow-Fiber Ultrafiltration Membrane with Sponge-like Structure

Study of poly(vinyl chloride)/polyether sulphone co-blend ultrafiltration membrane

Application of Optical Online Monitoring Method for Membrane Fouling and Resistance Build-up on Ultrafiltration Membranes

Polyethersulfone membrane modified by zwitterionic groups for improving anti-fouling and antibacterial properties

Preparation of PDMS/PES hollow fiber composite pervaporation membrane

Development of an antimicrobial and antifouling PES membrane with ZnO/poly(hexamethylene biguanide) nanocomposites incorporation

Polyethersulfone (PES) hollow fiber ultrafiltration membranes prepared by PES/non-solvent/NMP solution

Preparation of PES Hollow Fiber Composite Nanofiltration Membrane

Preparation, characterization and performance of polyethersulfone ultrafiltration membranes