Abstract:In this study, a polyarylate fiber rope, which is a high-strength synthetic fiber rope, is used in the wire drive mechanism of a multi-degree of freedom (DOF) robotic forceps to evaluate its mechanical practicability. Using a nonconducting material for the drive wire, different from typical use of metallic wires made of stainless steel and tungsten, a technology is developed to simplify the insulation structure significantly, decrease the diameter of the robotic surgical instrument, and lower its cost. In this study, first, a prototype of the multi-DOF robotic forceps equipped with a polyetheretherketone (PEEK) resin flexible wrist joint part with an external diameter of 5 mm is manufactured. The prototype is used to evaluate the assembling of a polyarylate fiber rope with a diameter of 0.34 mm in a multi-DOF mechanism and examine the endurance of the rope to mechanical motions under a single-use assumption. As fastening structures to assemble the rope – a crimp terminal using a hollow pipe and a thread knot – are examined individually by assembling them in the prototype robotic forceps and conducting strength tests of the tension generated by the drive. The test results show that the thread knot method exerts a stabler fastening strength than the hollow pipe method. However, a problem of the former is that the wire may break because of its strong contact with the edge of the hole of the wire guide. Subsequently, to evaluate the endurance of the rope to single-use operation motion, operation tests are conducted by implementing reciprocating bending motions of the flexible wrist joint part of the robotic forceps 1,000 times. The assembled rope endures the sliding within the flexible wrist joint part and the contact loading with the guide part and the fixed structure within the cartridge repeatedly. The endurance operation test results confirm that the drive transmission of the polyarylate fiber rope has sufficient mechanical endurance to 1,000 reciprocating bending motions of the PEEK flexible wrist joint part.

The design and the performance research of Kevlar-29 fiber based fixed point and forcebreaking rope

A novel fiber-reinforced polymer rope: Concept design and experimental evaluation

A novel fiber‐reinforced polymer rope: Simulation and theoretical investigation

Finite Element Analysis of Steel Wire Ropes Considering Creep and Analysis of Influencing Factors of Creep

A Three Dimensional Approach to Model Steel Wire Ropes Used in High Energy Absorber Apparatus

Impact failure mechanism of kernmantle ropes for fall protection from heights

Development and Experiment Research on Multi-function Wire Rope for Manned Rescue Lifting Equipment

Study of the Mechanical Properties of Ultra-High Molecular Weight Polyethylene Fiber Rope

Parametric modeling and finite element analysis of triangular strand wire rope

A novel mechanical design of broken rope protection device for enhancing the safety performances of overhead manned equipment in coal mine

Tensile properties and constitutive modeling of Kevlar29 fibers: from filaments to bundles

Design and test of new thermal knife restraint and release device

A molecular dynamics investigation of the mechanical properties of graphene nanochains

Abrasion performance and failure mechanism of fiber yarns based on molecular segmental differences

Preparation and the influence of twist factor on cut resistance performance of Kevlar short fiber covered yarn fabric

Bending fatigue damage behavior of wire rope in hoisting system of drilling rig

A New Fully-Detailed Finite Element Model of Spiral Strand Wire Ropes for Fatigue Life Estimate of a Mooring Line

Cyclic testing of continuously wetted synthetic fiber ropes

Application and Mechanical Evaluation of Polyarylate Fiber Rope in Wire Drive Mechanism of Robotic Surgical Instruments

Research on Dynamic Characteristics of Lifting Rope-Breaking for the Nuclear Power Crane

Study on bending fatigue failure behaviors of end-fixed wire ropes