Abstract:Planar steel plates have many advantages, including high precision, flexible outline shape fabrication, and convenient transportation and storage, which make them suitable for various steel structures (e.g., reticulated shell structures). However, the steel plates are not commonly used as structural members, because they have a relatively low out-of-plane flexural stiffness. To improve the flexural buckling resistance, a novel type of built-up plate member comprising two longitudinal plates is proposed in this study. Additionally, the flexural buckling behavior of the novel built-up members is investigated. A series of compression tests on 42 specimens of built-up plate members is conducted to determine the elastic and ultimate critical loads. Flexural buckling about the minor axis is observed to be the failure mode of the specimens. The equivalent slenderness ratio method is used to determine the theoretical elastic critical loads of the specimens. With consideration of the measured material properties, geometric imperfections, and residual stresses of the specimens, a refined finite-element model is developed to simulate the flexural buckling behavior. Furthermore, the applicability of two representative specifications (American and European) to the novel built-up member is discussed. The results indicate that the design strengths calculated using these specifications are generally conservative for determining the ultimate loads of the built-up plate members. Design curve “c” in Eurocode 3 is found to be the most suitable among the specifications of interest for determining the design strength. This study provides valuable guidance for the design of built-up plate members.

Analysis of Interactive Buckling and Width-thickness Ratio of I -shaped Member Under Axial Compression

Elastic Local Buckling and Width-to-Thickness Limits of I-Beams Incorporating Flange–Web Interactions

Elastic Buckling of Web Restrained by Flanges in I-section Members

Finite element analysis on shear capacity of the corrugated web H-shaped steel beam

LOCAL BUCKLING OF I-SECTIONS IN COMPRESSION AND BENDING

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER BENDING

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

ELASTIC SHEAR BUCKLING OF WEB PLATES IN TAPERED I-GIRDERS

Shear resistance of slender webs in I-girders

LOCAL AND DISTORTIONAL BUCKLING OF COLD-FORMED C AND Z-SECTION MEMBERS UNDER AXIAL COMPRESSION

A Controversy and Its Settlement in the Calculation of Buckling Moments of Thin-walled Beams with Monosymmetrical I-sections under Distributed Loads

Distortional and Lateral Buckling of Z-Purlins with Sloping Lips in Flexure

Elastic Flexural-Torsional Buckling of Doubly Symmetric Web-Tapered I-Beams

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

An Interactive Buckling Theory for Built-Up Beam-Columns and Its Application to Centrally Compressed Built-Up Members

Finite Element Analysis And Design Method Study On The Interactive Buckling Of Welded Steel Members Under Axial Compression

Study on behavior of slender H-section stub columns subjected to axial compression

Research on Stability Behavior of Flanges in H-shaped Members with Corrugated Web

Elsatic Out-of-plane Buckling of Hinged I-column with Tapered WEB

Post-buckling Analysis of Laminated Stiffeners

Buckling of Piecewise Member Composed of Steel and High-Strength Materials in Axial Compression