Effect of Moment of Inertia on Elastic Stability of Rectangular Webs for Thin-Walled Beams under A Transverse Load
Ruitao Niu,Weicheng Gao,Wei Liu
DOI: https://doi.org/10.1016/j.tws.2014.07.019
IF: 5.881
2014-01-01
Thin-Walled Structures
Abstract:So far, the equations for buckling capacity of web panels focus on thin-walled beams with very strong flanges. In this paper, elastic buckling behavior of web panels of thin-walled beams with weak flanges is further studied, aiming at a buckling coefficient formula unifying the effect of both weak and strong flanges. A new parameter, the flange-to-web ratio of moment of inertia, is proposed to characterize the effect of flanges. Then, a semi-analytical method is applied to investigate the buckling behavior of simply supported web panels, in two cases, inclusive or exclusive of effect of the moment of inertia of flanges. It is revealed that elastic buckling load, in particular, the buckling coefficient of web panel is a function of two key parameters, web aspect ratio and flange-to-web ratio of moment of inertia. Meanwhile, a finite element analysis (FEA) model allowing for the sensitivity of boundary conditions is validated by comparing with the semi-analytical solution to the case exclusive of effect of the moments of inertia of flanges. Next, numerical results are utilized to illustrate the influence of the previous parameters, which verify the increase of buckling coefficient with flange-to-web ratio of moment of inertia or the decrease of buckling coefficient with web aspect ratio. Besides, it also verifies that for the same flange-to-web ratio of moment of inertia, the buckling behavior of square web panels is closer to the uniform shear buckling than other rectangular web panels. Finally, an accurate design formula is proposed to calculate buckling coefficient of web panel.