Abstract:Abstract Automotive engine downsizing has placed an increased focus on the ability of the turbocharger to provide adequate boost levels across the full engine operating rage. To achieve the desired levels of turbocharger performance the turbine must be capable of operating effectively at the intended design point and also at off-design conditions. Mixed flow turbines (MFTs) provide a potential method to improve performance at off-design conditions and during transient engine operation. A unique feature of a MFT is the spanwise variation of incidence angle at the rotor leading edge. This results in additional flow separation from the blade suction surface near the hub under a wide range of operating conditions. The flow separation generates additional loss and has a detrimental impact on turbine performance. A novel design of turbine volute similar to a conventional twin-entry turbine volute was examined. The novel turbine volutes were designed to produce a spanwise variation in flow conditions at the rotor inlet. The primary objective was to reduce the incidence angle and increase the mass flow rate at the hub side of the passage relative to the shroud side, as it has previously been identified that this can be beneficial for MFT performance. A number of different volute geometries were examined by numerical analysis to determine the impact of key parameters on turbine performance. The results indicated that generating a suitable spanwise flow distribution could produce a moderate improvement in turbine efficiency at off-design operating conditions. The novel volute design also provided a means of achieving a degree of variable geometry operation to further improve off-design performance. Turbine performance was examined under the variable geometry operation and an improvement in turbine power output at low speed, off-design conditions was achieved. This was analogous to operating with a conventional pivoting vane variable geometry system and had the potential to benefit performance during transient engine operation.

Experimental Research on Aerodynamic Performance of Variable Geometry Low Pressure Turbine

Aerodynamic Performance Analysis of a Novel Geometry-variable Turbine Guide Vane with a Fixed Angle of Attack

Experimental Study on the Aerodynamic Performance of Variable Geometry Low-Pressure Turbine Adjustable Guide Vanes

Experimental and numerical investigations of tip clearance flow and loss in a variable geometry turbine cascade

Numerical and Experimental Study of the Performance Effects of Varying Vaneless Space in High-Speed Micro Turbine Stators

An Investigation Of The Flow Structures And Flow Control In A Variable Geometry Turbine

Investigation of a Novel Turbine Housing to Produce a Non-Uniform Spanwise Flow Field at the Inlet to a Mixed Flow Turbine and Provide Variable Geometry Capabilities

Aerodynamic and Performance Behavior of A Radial Turbine at Design and Off-Design Conditions

A Numerical Investigation of Variable Geometry Turbine's Flow Mechanism and Aerodynamic Performance

Research of Design Method of Variable Area Nozzle Turbine for Variable Cycle Engine

Numerical Investigation of the Effect of Rotor Blade Leading Edge Geometry on the Performance of A Variable Geometry Turbine

Aerodynamic performance measurement of a novel variable geometry turbine adjustable guide vane scheme by experimental study

Advances in variable geometry turbine aerodynamic technology for gas turbines

A Novel Design Towards Reducing Leakage Loss for Variable Geometry Turbines

Improved clearance designs to minimize aerodynamic losses in a variable geometry turbine vane cascade

Numerical Simulation of Flow Fields and Performance of Spherical End wall Variable Geometry Turbine

Design and Analysis of LP-vaneless Contra-Rotating Turbine

Experimental and Numerical Investigation on Flow Characteristics of a Vaneless Counter-Rotating Turbine at Off-Design Conditions

Numerical Investigation on Effects of Leakage Flow on the Aerodynamic Performance of Turbine Stages

Experimental Study on the Aerodynamic Characteristics of Blades at the Last Stage of a Steam Turbine at Off-Design Conditions

DESIGN, MULTI-POINT OPTIMIZATION AND ANALYSIS OF DIFFUSIVE STATOR VANES TO ENABLE TURBINE INTEGRATION INTO ROTATING DETONATION ENGINES