Abstract:Variable geometry turbines (VGT) hold a crucial role in gas turbines and variable cycle engines (VCE) by allowing adjustments to different operational conditions. In order to realize the adjustable function of the VGT stator blade, there will be partial gap structure at both ends of the stator blade, which will lead to partial leakage flow and serious secondary flow loss at the blade end that cannot be ignored, especially in a large angle adjustment range. At present, there are few researches on turbine cascades considering the real partial gap structure and winglet tip, and the numerical simulation calculation is mainly used, while the in-depth study using wind tunnel test is rarely seen. Therefore, this study attempts to analyze the internal flow characteristics of variable geometry turbine cascade by using five-hole pneumatic probe scanning and surface oil flow visualization, and discusses the mechanism of controlling partial clearance leakage flow and reducing secondary flow loss in the cascade by using winglet tip flow control technology. The winglet offset distance and the change of the relationship between the pivot and the clearance position on the flow field and flow loss is studied experimentally for the first time. The results show that the influence mechanism of winglet tip applied in VGT partial gap is quite different from that of typical blade tip clearance application, and more consideration should be given to the influence of pivot structure. Reasonable parameter selection can achieve a maximum loss reduction of 13.4 % and 20.2 % with and without pivot, respectively, while the unreasonable flow control scheme may lead to the loss or even increase with pivot. The interaction between the new secondary flow structure induced by pivot in the gap and other gap leakage flows is analyzed to explore the new mechanism of using winglet tip to reduce the loss of gap leakage flow.

Numerical Investigation of the Effect of Rotor Blade Leading Edge Geometry on the Performance of A Variable Geometry Turbine

An Investigation Of The Flow Structures And Flow Control In A Variable Geometry Turbine

Performance Impact of Flow and Geometric Variations for a Turbine Blade Using an Adaptive NIPC Method

Numerical Investigation on the Effects of Airfoil Leading Edge Radius on the Aerodynamic Performance of H-Rotor Darrieus Vertical Axis Wind Turbine

Experimental and numerical investigations of tip clearance flow and loss in a variable geometry turbine cascade

Study on the Effects of Blades Outer Angle on the Performance of Inline Cross-Flow Turbines

Investigation of Unsteady Aerodynamic Excitation on Rotor Blade of Variable Geometry Turbine

Study on the Effects of Runner Geometries on the Performance of Inline Cross-Flow Turbine Used in Water Pipelines

The Effect Of Leading Edge Curvature On A Mixed Flow Turbine Performance Under Pulsating Flow Conditions

The Effects of Variable Geometry Turbine on the Turbine Aerodynamic Performance

Experimental investigation of secondary flow losses in a variable geometry linear turbine cascade with winglet tip

AERODYNAMIC PERFORMANCE OF PARTIALLY VARIABLE GEOMETRY HIGH-PRESSURE TURBINE

Numerical and experimental study on the critical geometric variation based on sensitivity analysis on a compressor rotor

Numerical and Experimental Investigation of the Impact of Mixed Flow Turbine Inlet Cone Angle and Inlet Blade Angle

Numerical Analysis of Leading-Edge Roughness Effects on the Aerodynamic Performance of a Thick Wind Turbine Airfoil

Computational investigation of the aerodynamics of automotive turbocharger mixed-flow turbines

Numerical Study on Flow and Heat Transfer Characteristics of Swirl Cooling on Leading Edge Model of Gas Turbine Blade

A Novel Design Towards Reducing Leakage Loss for Variable Geometry Turbines

Numerical Studies On Improving Performance Of Rotor-67 By Blended Blade And Endwall Technique

Improving Vibration Response of Radial Turbine in Variable Geometry Turbochargers With CFD Analysis

Aerodynamic Performance Comparisons of Two Kinds of Variable Nozzle Vanes for a Variable Geometry Turbine