Abstract:The adoption of a numerical method to perform vibration and acoustic analyses is attracting increasing attention because of its merits in saving costs and time. The analysis flow chart of structure-borne noise reduction by controlling the vehicle body panel vibration is proposed. A finite element analysis of a body in white is performed according to this flow chart, using MSC. Nastran, and the experimental modal analysis of a body in white is also carried out. To verify the finite element model, a correlation analysis between the test and the finite element results is performed. After the acoustic boundary element model with seats has been constructed, the acoustic transfer vector is calculated using LMS software. A transfer path analysis is performed to estimate the powertrain and exhaust pipe operational forces at idle. Then the forces are input into the acoustic boundary element model to calculate the body panel velocity. By combining the acoustic transfer vector and the body panel velocity, the interior acoustic response can be obtained. The simulation results are verified by tests. To determine the main contribution panels for the interior sound pressure level, a panel acoustic contribution analysis is based on the boundary element method. Finally, constrained damping treatments are adopted to control the main panel vibration based on the results of the panel acoustic contribution analysis. The test results indicate that the sound pressure level of the interior noise at idle is reduced obviously before and after treatments, which has proved the correctness of the results from the panel acoustic contribution analysis. Therefore it is believed that the proposed analysis method is feasible for reducing interior structure-borne noise.

Interior Noise Reduction Scheme Based on Phonon Crystal and Its Defect Characteristics

An Investigation on Interior Noise Reduction Using 2D Locally Resonant Phononic Crystal with Point Defect on Car Ceiling

Research on Multi-Band Structural Noise Reduction of Vehicle Body Based on Two-Degree-of-freedom Locally Resonant Phononic Crystal

Study on broad flexural wave bandgaps of piezoelectric phononic crystal plates for the vibration and noise attenuation

Vibration Reduction of Car Body Based on 2D Dual-Base Locally Resonant Phononic Crystal

Research on Tunable Bandgap Characteristics of the Phononic Crystal Duct with Piezoelectric Thin Plates for the Broad Noise Reduction

Research on Control of Car Interior Noise due to Engine Vibration

Application Research of Phononic Crystals to Reduce Body Ceiling's Vibration

The Phononic Crystals and Automobile Vibration Noise Control

Interior Structure-Borne Noise Reduction by Controlling the Automotive Body Panel Vibration

Vehicle Interior Low Frequency Noise Prediction and Its Control

Applications of the phononic crystal structures to the reduction of brake Noise

Investigation on Technology of Automobile Vibration and Noise Reduction Based on Body-In-White Structure

Research and Simulation Analysis of Fuel Cell Vehicle Interior Noise

Acoustic and Aerodynamic Performances of One Phononic Crystal Duct with Periodic Mufflers

Research on the Interior Noise Reduction of an Elastic Cavity by the Multipoint Panel Acoustic Contribution Method Based on Moore–Glasberg Loudness Model

Optimal design of vehicle cavity fillers' arrangement based on flow of acoustic power

Acoustic Attenuation Characteristics of the Muffler Phononic Crystal with Hybrid Resonators

Car Internal Noise Control Using Finite Element Method

Experimental Research of Interior Noise Reduction for Passenger Car

New Design Method of Car Body to Lower Interior Noise