Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Interior Noise Analysis of a Non-load Type Body SUV

Investigation of Multi-Degree of Freedom Damped Dynamic Absorber Applied to Wheel Noise Control

Analyses on Vehicle Ride Comfort Based on Virtual Prototype Technology

A Novel Interval Analysis Method to Identify and Reduce Pure Electric Vehicle Structure-Borne Noise

Identification of dominant interior noise sources in micro commercial vehicle based on sound quality analyzing

Identification of Vehicle’s Interior Noise Sources by Using Operational Transfer Path Analysis

Analysis and Optimization of Low-Speed Road Noise in Electric Vehicles

Damping Optimization Noise Reduction Technique Based on Modal and Panel Contribution Analysis

Analysis and study of the transmission path based on the body and NVH

Identification of Perceived Sound Discomfort Contributed from Partially Correlated Vibration and Noise Sources in Vehicles

Vibration and Acoustic Analysis of a Mobile Device

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Vibration transfer path analysis and path ranking for NVH optimization of a vehicle interior

THE STRUCTURAL VIBRATION ANALYSIS METHOD FOR VEHICLE'S NOISE FACTOR

Auto-body NVH Structure Sensitivity Analysis Based on Modal Analysis Method

Coupled Analysis of Engine Noise and Interior Noise of an Automobile

Subjective evaluation test and objective quantificational description of vehicle interior noise quality

Test Analysis and Identification of Noise Inside a Pure Electric Vehicle

Study On Adaptive Active Control Of Unstable Noise In Vehicle

An Analysis Study on the Effects of Tire Wear on the Interior Vibration and Noise of Vehicles

TRANSFER PATH ANALYSIS AND CONTROL OF AUTOMOTIVE INTERIOR STRUCTURE-BORNE NOISE GENERATED BY A POWERPLANT