Abstract:Recently, the study on elastic waves in phononic crystal plates is becoming a research hotspot due to its potential applications, especially in wireless communication, transducer and sensor system [1-10]. The phononic crystal plates commonly consist of two materials with large contrast in elastic properties and densities, arranging in a periodic (or quasiperiodic) array. The absolute band gaps in composite plates can forbid the propagation of all elastic wave modes in all directions. Comparing with the bulk wave and surface acoustic wave devices, phononic crystal plates have better performance in elastic wave propagation since the phase speed of most Lamb wave modes (except for A0 mode) is faster than surface wave mode, and also the wave energy in plates is totally confined between the upper and nether free-stress boundaries regardless of the air damp and self-dissipation, which provides a special potentiality in micro-electronics in wireless communication. The propagation of Lamb waves is much more complicated than bulk wave and surface acoustic wave in terms of the free-stress boundaries which can couple the longitudinal and transversal strain components. The first attempt to describe the propagation of Lamb waves with wavelength comparable with the lattice is due to Auld and co-workers [11-12], who studied 2D composites within the couple-mode approximation. Alippi et al. [13] have presented an experimental study on the stopband phenomenon of lowest-order Lamb waves in piezoelectric periodic composite plates and interpreted their results in terms of a theoretical model, which provides approximate dispersion curves of the lowest Lamb waves in the frequency range below the first thickness mode by assuming no coupling between different Lamb modes. The transmissivity of the finite structure to Lamb wave modes was also calculated by taking into account the effective plate velocities of the two constituent materials [14]. Based on a rigorous theory of elastic wave, Chen et al.[1] have employed plane wave expansion (PWE) method and transient response analysis (TRA) to demonstrate the existence of stop bands for lower-order Lamb wave modes in 1D plate. Gao et al.[8] have developed a virtual plane wave expansion (V-PWE) method to study the substrate effect on the band gaps of lower-order Lamb waves propagating in thin plate with 1D phononic crystal coated on uniform substrate. They also studied the quasiperiodic (Fibonacci system) 1D system and find out the existence of split in phonon band gap [2]. In order to reduce the computational complexity without losing the accuracy, Zhu et al.[9] have promoted an efficient method named harmony response analysis (HRA) and supercell plane wave expansion (SC PWE) to study the behavior of Lamb wave in silicon-based 1D composite plates. Zou et al.[10] have employed V-PWE method to study the band gaps of plate-mode waves in 1D piezoelectric composite plates with substrates.

A locally-resonant phononic crystal for low-frequency vibration control of vehicles

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Multi-band Design for One-Dimensional Phononic Crystals

Analysis of Vibration-Damping Characteristics and Parameter Optimization of Cylindrical Cavity Double-Plate Phononic Crystal

A metamaterial for low-frequency vibration damping

An Inertant Elastic Metamaterial Plate with Extra Wide Low-Frequency Flexural Band Gaps

Low-Frequency Bandgap Characterization of a Locally Resonant Pentagonal Phononic Crystal Beam Structure

Vibrational loss analysis of a new type of phononic crystal with a tungsten block embedded inside a rubber matrix

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

Tunable Bandgaps in Soft Phononic Plates with Spring-Mass-like Resonators

Tunable characteristics of low-frequency bandgaps in two-dimensional multivibrator phononic crystal plates under prestrain

Low-frequency broadband vibration reduction based on a square spiral beam local resonance phononic crystal

Bandgaps and vibration isolation of local resonance sandwich-like plate with simply supported overhanging beam

Theoretical and experimental investigation on the low-frequency vibro-acoustic characteristics of a finite locally resonant plate

Three-dimensional Chiral Meta-Plate Lattice Structures for Broad Band Vibration Suppression and Sound Absorption

Design of Low-Frequency 1D Phononic Crystals Harnessing Compression–twist Coupling Effect with Large Deflection Angle

Thermal Tuning of the Interfacial Adhesive Layer on the Band Gaps in a One-Dimensional Phononic Crystal

Low-frequency locally resonant band-gaps in phononic crystal plates with periodic spiral resonators

Design of novel two-dimensional single-phase chiral phononic crystal assembly structures and study of bandgap mechanism

Acoustic Waves In Phononic Crystal Plates

Study on low-frequency bandgaps and sound isolation characteristics of a novel Helmholtz type phononic crystal