Abstract:Abstract Accurate measurement of the volumetric flowrate of working liquids is essential for process control, as well as energy consumption evaluation. Electromagnetic flowmeters have gained popularity in applications where low-pressure drop and low maintenance are required. Dwyer Instruments, Inc. recently developed an adjustable insertion electromagnetic flowmeter (IEF) featuring accurate and reliable measurement. However, unexpected and non-repeatable behavior in the K-factor was observed during the calibration process. The K-factor is the coefficient used to convert the measured electric potential to the flow velocity in pipes, and the non-repeatable behavior imposes challenges for precise measurement. A one-way coupled magnetohydrodynamics model was developed to reduce the effort and time of onsite troubleshooting and optimization. By modeling the measurement process, the transition of flow regimes and the regeneration of the boundary layer on the electrode surface were identified as the causes of the non-repeatable issue. Then, a series of parametric studies were performed to provide reliable solutions. A new design with further embedded electrodes to allow the smooth transition between boundary layers was recommended. The field test showed excellent repeatability by using the new design, and the non-repeatable issue was entirely resolved. The improvement in the IEF design was implemented in production in less than one week, and it reduced the calibration time by 50%.

Calibration and Error Analysis of Differential Pressure Flow meter

Study of No-liquid Calibration Technique for the Medium-and-large Diameter Electromagnetic Flowmeter

Design and Error Analysis on Pressure Measurement System of Low Speed Pressurized Wind Tunnel

Design of a Flow Automatic Calibration System Based on the Master Meter and Dynamic Weighing Methods

Comparisonstudies on flow measurement methods for cylinder water hole in diesel engine

Calibration Analysis of H-ADCP Automatic Flow Measurement System in Wangting (Interchange) Hydrological Station

Calculation and judgment of repeatability error affected by non-linearity correction based on flowmeter characteristic analysis

Comparison of Measurement Performance between Piezoelectric and Differential-pressure Vortex Flowmeters

Numerical Simulation and Experimental Research on Measurement Characteristics of Elbow Meter

Design and Research of Signal Acquisition Circuit of Thermal Gas Flow-Meter

ANALYSIS ON THE INFLUENCE OF THE SYSTEM PARAMETER OF ROOTS STANDARD FACILITY ON THE INTELLIGENCE FLOWMETER

Error Analysis of Gas and Liquid Flow Rates Metering Method Based on Differential Pressure in Wet Gas

An Approach for Enhancing Dynamic Characteristics of Differential Pressure Flow Meters

Analysis of mechanism producing error at flowmeter of pressuredifference type and improvement

Study on the measurement error of differential pressure flowmeter in pulsating flow

Design and Fluid–structure Interaction Analysis of a Micromachined Cantilever-Based Differential Pressure Flow Sensor

Research on liquid flow standard facilities and automatic calibration systems

Dry Calibration Technique of Electromagnetic Flowmeters

Model simulation and error quantitative analysis of pipeline of ultrasonic gas flowmeter

Error Analysis and Accuracy Calibration Method of U-Tube Coriolis Mass Flowmeter Under Pulsating Flow

Calibration and Optimization of an Insertion Electromagnetic Flowmeter With the Aid of Numerical Analysis