Abstract:The successive approximation register (SAR) ADC is the most energy efficient architecture with moderate conversion rate and resolution. However, its comparator noise limits its resolution without sacrificing power efficiency. The delta-sigma modulator (DSM) is the most popular architecture for achieving high SNDR due to its oversampling, but the bulky operational amplifier (op-amp) makes it area inefficient. In LTE Advanced, the bandwidth (BW) of downlink ADCs needs to be configured according to the number of inter-band non-contiguous carrier aggregation (NCCA), which motivates us to combine the benefits of both architectures to reduce area and power consumption simultaneously with high SNDR. The noise-shaping SAR ADC [1] suppresses the comparison and quantization noise in signal BW using a simple cascaded FIR-IIR filter, which obviates the need for a power-hungry low-noise comparator or high-performance op-amp. To some extent, the noise-shaping SAR ADC is a hybrid of DSM and SAR ADCs. Hence, it has the potential to achieve the high resolution and good power efficiency of DSM and SAR ADCs, respectively. However, the passive sampling in an FIR filter introduces considerable thermal noise to the ADC, making it difficult to achieve a high SNR. This work presents an energy-efficient noise-shaping SAR ADC that uses a gain-enhanced dynamic amplifier and some capacitors to construct a low-noise dynamic FIR-IIR filter. The prototype achieves a peak SNDR of 79.74dB over a 5MHz BW with a power consumption of 0.46mW from a 1V supply.

An Area-Power-Efficient AFE with NS-SAR ADC for High-Frequency Ultrasound Applications

A 16-Channel 12-Bit Rail-to-rail Successive Approxmation Register ADC for AFEs

A 1.5 Mw 68 Db SNDR 80 Ms/s 2<formula Formulatype="inline"> <tex Notation="TeX">$\times$</tex></formula> Interleaved Pipelined SAR ADC in 28 Nm CMOS

An RX AFE With Programmable BP Filter and Digitization for Ultrasound Harmonic Imaging

Energy-Efficient Analog Frond-End Design for Ultrasound Imaging Applications

A Wide-Range 12b 150ms/s P-SAR ADC with Open-Loop Residue Amplifier for Ultrasound AFE.

28-Nm CMOS Ultrasound AFE with Split Attenuation for Optimizing Gain-Range, Noise, and Area

A 20mhz Bandwidth Band-Pass Noise-Shaping SAR ADC with OPAMP Sharing Switched-Capacitor Filter

A 1.54mW/Element 150μm-Pitch-Matched Receiver ASIC with Element-Level SAR/Shared-Single-Slope Hybrid ADCs for Miniature 3D Ultrasound Probes

Low-Noise Low-Power Ultrasound AFE with Continuous TGC Built in Both TIA and Beamformer.

A Pitch-Matched Front-End ASIC with Integrated Subarray Beamforming ADC for Miniature 3-D Ultrasound Probes

An 871nw 96.2Db-Sndr Pipelined NS SAR ADC Achieving 180.8Db-Fomsndr with a Charge-Efficient CLS-Assisted Two-Stage FIA

A 48-Channel High-Resolution Ultrasound Beamforming System for Ultrasound Endoscopy Applications

9.3 A 71dB SNDR 200MHz BW Interleaved Pipe-SAR ADC with a Shared Residue Integrating Amplifier Achieving 173dB FoMs.

A 16-Channel 50ms/s 14bit Pipelined-SAR ADC for Integrated Ultrasound Imaging Systems.

Low-Power Low-Noise Amplifier Using Attenuation-Adaptive Noise Control for Ultrasound Imaging Systems

A Ring Amplifier Based Current Feedback Continuous Time PGA for High Frequency Ultrasound Applications

28.1 A 0.46mW 5MHz-BW 79.7dB-SNDR noise-shaping SAR ADC with dynamic-amplifier-based FIR-IIR filter

A Calibration-Free, 16-Channel, 50-Ms/s, 14-Bit, Pipelined-SAR ADC with Reference/Op-Amp Sharing and Optimized Stage Resolution Distribution

An element-matched band-pass delta-sigma ADC for ultrasound imaging

Development of Integrated Preamplifier for High-Frequency Ultrasonic Transducers and Low-Power Handheld Receiver