Abstract:Silicon photomultipliers (SiPM) are rapidly adapted in simultaneous time of flight (TOF) PET and MRI imaging system in recent years due to its fast timing response and immunity to magnetic field. The aim of this work is to develop multi-channel fast SiPM readout electronics for clinical TOF PET detector. The detector module is assembled by directly coupling a 12x12 LYSO crystal block to an 8x8 Sensl FB30035 SiPM array. We are developing two approaches of compact readout electronics to handle the large number of SiPM output channels. One is a low noise and high bandwidth, 128-channel ASIC to readout the 64 fast outputs and 64 standard outputs of the 8x8 SiPM array. The other approach is a conventional electronics based multiplexing readout scheme using discrete components. A charge division resistor network reduced 64 channels of standard output to four energy signals, and multiplexing and summing circuits reduced 64 channels of fast output to one timing signal, making the detector block highly compact and scalable. The ASIC design has been finished and it's ready for tape-out. Preliminary performance of the detector module readout by conventional electronics was evaluated. 12x12 LYSO crystals were well resolved and identified in the flood image and the average energy resolution was 15.6% +/- 1.3%. For single crystal pair, 240ps coincidence resolving timing (CRT) was achieved. It was dropped down to 500ps for detector block to single crystal configuration, due to the combination effects of: 1) degradation of fast signal rising edge by output capacitance addition of SiPMs and 2) large white electronic noise and ultrahigh dark count rate. The readout design will be further optimized by increasing the signal bandwidth and reducing noise to get better timing performance at a cost of increasing circuit complexity to a reasonable level. The performance of ASIC readout will be evaluated and good timing performance is expected due to the individual pixel timing pick-off.

Design of the Time Measurement Circuit, Single Data Frame Sorting, and Packaging Logic of a TOF PET System

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Testing of Singles Processing Unit for a Brain PET

Prototype design of singles processing unit for the small animal PET

Initial Testing of Singles Processing Unit for the Small Animal PET

Sub-Detector Unit Timing Calibration for Brain Pet Based on L1-Norm Constraint

An FPGA-Based Fast Linear Discharge Readout Scheme Enabling Simultaneous Time and Energy Measurements for TOF-PET Detectors

Scalable electronic readout design for a 100 ps coincidence time resolution TOF-PET system

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet

Design and Performance Optimization of SiPM Array Multiplexing Readout Circuit

Timing Optimization with Position Information for TransPET

Development of a Compact DOI–TOF Detector Module for High-Performance PET Systems

A 71Ps-Resolution Multi-channel CMOS Time-to-Digital Converter for Positron Emission Tomography Imaging Applications

An FPGA-based Time Sampling Charge Measurement Method for TOF-PET Detectors

Investigation of Electronic Signal Processing Chains for a Prototype TOF-PET System With 100-ps Coincidence Time Resolution

Development and Evaluation of a New High-Tof-resolution All-Digital Brain PET System.

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

Real-Time FPGA-based Digital Signal Processing and Correction for a Small Animal PET

A Simple All-Digital PET System

An Investigation of Digital Signal Processing for Shaped Pulses for All-Digital Pet