Abstract:Unlike uniform motion, when an object moves underwater with variable speed, it experiences additional resistance from the water, commonly referred to as added mass force. At present, several methods exist to solve this force, including theoretical, experimental, and simulation approaches. This paper addresses the challenge of determining the added mass force for irregularly shaped small objects undergoing variable speed motion underwater, proposing a method to obtain the added mass force through numerical simulation. It employs regression analysis and parameter separation analysis to solve the added mass force, added mass, viscous drag coefficient, and pressure drag coefficient. The results indicate that an added mass force exists during both the acceleration and deceleration of the object, with little difference between them. Under the same velocity conditions, significant differences exist in pressure drag forces, while differences in viscous drag forces are not significant. This suggests that the primary source of added mass force is pressure drag, with viscous drag having little effect on it. During acceleration, the surrounding fluid accelerates with the object, increasing the pressure drag with a high-pressure area concentrating at the object's front, forming an added mass force that is directed backward. By contrast, during deceleration, the fluid at the object's front tends to detach, and the fluid at the rear rushes forward, leading to a smaller high-pressure area at the front and a larger one at the rear, reducing the pressure drag and forming an added mass force that is directed forward. By comparing the added mass of a standard ellipsoid obtained from numerical simulation with theoretical values, the regression analysis method is proven to be highly accurate and entirely applicable for solving the added mass of underwater vehicles.

Identification of added mass according to frequency response function test data

Numerical analysis of added mass arising from fluid flow induced by vibration of three-dimensional structure

Numerical Calculation of Additional Mass for Undersea Vehicle

Added Mass Matrix Estimation of Beams Partially Immersed in Water Using Measured Dynamic Responses

Numerical Simulation and Analysis of Added Mass for the Underwater Variable Speed Motion of Small Objects

Strength Analysis of the Connected Structure in the Underwater High-Speed Vehicle

Numerical method for added mass of an underwater glider

Investigation of added mass for rigid body based on vibration test

3D Analysis Method for Added Mass Matrix about Free Vibration of Structure in Water

Numerical Studies of Added Mass Based on the CFD Method

STRUCTURAL DAMAGE IDENTIFICATION BY ADDING GIVEN MASSES

Numerical Study on the Impact Load Characteristics of a Trans-Media Vehicle During High-Speed Water Entry and Flat Turning

Research on Numerical Method for Added Water Mass of Twin Cylinders Based on Dynamic Mesh

Modeling and system analysis of floating underwater vehicle with variable mass and center of gravity

Numerical Investigation on Added Mass of Circle Membrane Vibrating in Still Air

Added Moss Coefficient of a Moored Ship

Numerical Investigation on Added Mass and Damping Force Coefficient of an Underwater Vehicle in Cavitating Flows

Calculation of Finite Cylinder Radial Added-mass and Engineering Applications

On the integral transform method for dynamic response solutions of simply supported Kirchhoff plates with underwater explosion loading

Numerical investigation of added mass coefficient of a subsea manifold in the accelerating flow and oscillating flow

Study of the influence of added water and contained water on structural vibrations and acoustic radiation using different dynamic modeling methods