Abstract:The high-speed water entry problem of a rotating body has instantaneous and strong nonlinear characteristics. In order to study the unsteady evolution of the multiphase flow field entering the water and the coupling effect of multiple media and analyze the influence of the noise of different structures, the fluid–structure-acoustic coupling method is used to analyze the numerical simulations of high-speed vertical water entry with different structures are carried out. In this article, we use different materials and structural forms of rigid cylinder, elastic cylinder and concave-head cylinder to analyze the unsteady evolution of the flow field during the water entering process, the dynamic response of the structure and the water flow noise. Through the comparison and analysis of different materials and structural forms, it can be found that the impact load of the rigid cylinder to the water has increased significantly and appeared earlier, the diameter of the cavity contour of the rigid cylinder is small, and the cavity and contraction of the tail of the concave-head cylinder faster. At the same time, the stress distribution of the elastic cylinder and the bottom of the concave-head cylinder is annular, and expands outward along the bottom center, and the stress transmission of the side surface of the concave-head cylinder is faster. Finally, the overall sound pressure level (OSPL) of the three different structures inflow noise at different distances in the four azimuths has basically the same change, and shows a ”saddle-shaped” trend. The research results in this paper can provide a certain reference for the study of multiphase flow field evolution, structural dynamic response characteristics and noise characteristics of high-speed entering water.

Numerical Study on the Impact Load Characteristics of a Trans-Media Vehicle During High-Speed Water Entry and Flat Turning

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

Formulations of Hydrodynamic Force in the Transition Stage of the Water Entry of Linear Wedges with Constant and Varying Speeds

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

Design and Analysis of Co-axial Twin-Propeller Trans-media Vehicle.

Numerical Study of Violent Impact Flow Using a CIP-Based Model

Exploring the load characteristics and structural responses of a high-speed vehicle entering water

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Simulation and experimental research on trans-media vehicle water-entry motion characteristics at low speed

A CIP-based Numerical Simulation of Freak Wave Impact on a Floating Body

Numerical Simulation of the Horizontal Water-Entry Process of High-Speed Vehicles

Numerical study on the dynamic characteristics of a vehicle with a multistage load reduction structure during oblique water entry

Numerical study of hydrodynamic loads at early stage of vertical high-speed water entry of an axisymmetric blunt body

Numerical analysis of cavitation and impact load characteristics of supercavitating vehicle entering water at high speed

Numerical Study of Flat Plate Impact on Water Using a Compressible CIP–IBM–Based Model

Numerical Research on Impacting Load and Structural Response for a Model Experiment of High-speed Craft

Experimental investigation on the slamming loads of a truncated 3D stern model entering into water

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

Dynamics analysis of high-speed water entry of axisymmetric body using fluid-structure-acoustic coupling method

Numerical study of wave effect on water entry of a three-dimensional symmetric wedge

Experimental and Numerical Prediction of Slamming Impact Loads Considering Fluid–Structure Interactions