Abstract:Unlike uniform motion, when an object moves underwater with variable speed, it experiences additional resistance from the water, commonly referred to as added mass force. At present, several methods exist to solve this force, including theoretical, experimental, and simulation approaches. This paper addresses the challenge of determining the added mass force for irregularly shaped small objects undergoing variable speed motion underwater, proposing a method to obtain the added mass force through numerical simulation. It employs regression analysis and parameter separation analysis to solve the added mass force, added mass, viscous drag coefficient, and pressure drag coefficient. The results indicate that an added mass force exists during both the acceleration and deceleration of the object, with little difference between them. Under the same velocity conditions, significant differences exist in pressure drag forces, while differences in viscous drag forces are not significant. This suggests that the primary source of added mass force is pressure drag, with viscous drag having little effect on it. During acceleration, the surrounding fluid accelerates with the object, increasing the pressure drag with a high-pressure area concentrating at the object's front, forming an added mass force that is directed backward. By contrast, during deceleration, the fluid at the object's front tends to detach, and the fluid at the rear rushes forward, leading to a smaller high-pressure area at the front and a larger one at the rear, reducing the pressure drag and forming an added mass force that is directed forward. By comparing the added mass of a standard ellipsoid obtained from numerical simulation with theoretical values, the regression analysis method is proven to be highly accurate and entirely applicable for solving the added mass of underwater vehicles.

Investigation of added mass for rigid body based on vibration test

Numerical analysis of added mass arising from fluid flow induced by vibration of three-dimensional structure

Study on Fluid-Solid Coupling Dynamic Characteristics of Large Wide-Frequency-range Underwater Vibration Tables

STUDY ON PILE LONGITUDINAL VIBRATION CONSIDERING EFFECT OF UNDERGROUND WATER LEVEL

Study on Resistance Factor of Saturated Soil Caused by Longitudinal Vibration of Pile

Estimation of Tension Force in Short Hangers Using Added Mass Method

Study of the influence of added water and contained water on structural vibrations and acoustic radiation using different dynamic modeling methods

Numerical Simulation and Analysis of Added Mass for the Underwater Variable Speed Motion of Small Objects

Relative Vibration of Suspended Particles with Respect to Microchannel Resonators and Its Effect on the Mass Measurement

Modeling and system analysis of floating underwater vehicle with variable mass and center of gravity

Experimental Investigation of the Effects of Extra Mass on a Piano Soundboard’s Vibration Property

Estimation of mass and moisture content of flat square lumber in a stack during air-drying process by the vibration method with additional mass

Dynamic Experimental Investigation On The Self-Vibration Characteristics Of Liquid Storage Tanks Under Seismic Excitations

A New Simulation Model for Hydrodynamic Behavior of Rigid Body in Narrow Space

The Parameters Calibration of Additive Mass Method and Its Application in Compaction Density Measurement of Soil Rock Mixtures

Investigation of the effect of the added mass fluctuation and lateral vibration absorbers on the vertical nonlinear vibrations of the offshore wind turbine

Removing adverse effect of measurement process in flotation method

A Proposal For Absolute Determination Of Inertial Mass By Measuring Oscillation Periods Based On The Quasi-Elastic Electrostatic Force

Numerical and experimental investigation of vibro-acoustic characteristics of a submerged stiffened cylindrical shell excited by a mechanical force

Experimental Calculation of Added Masses for the Accurate Construction of Airship Flight Models

Study of shaking table substructure test loading by inertial mass